Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Water pump impeller shot

Join Wrangler Forum Today

Thread: Water pump impeller shot Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-11-2011 10:17 PM
WBN3 The one I put on it is an aftermarket from AutoZone. Here is a picture of the pump I took off... can you tell whether it is OEM or reman? My son thought the little star on the right looked like the Chrysler logo...

And a close-up of the casting...

Just wondering... someone else told me the freeze plugs are probably not far from failure, based on the amount of corrosion that must have taken place to damage that impeller. I have also heard that most of the damage could've been cavitation rather than chemistry... hard to know what to believe.
06-11-2011 07:31 PM
Shelby427 Hmm, seeing that both pump housings aren't identical, it could be that a cheap overseas rebuilt pump was once used. Poor metal quality and poor coolant condition could cause the impeller to rust and wear away, and would be accelerated by a bunch of trash flowing around in the coolant.
06-11-2011 10:00 AM
Water pump impeller shot

Folks - posted this in follow-up to another thread, but wondered if anyone had seen this kind of damage to a water pump impeller before.

A little closer look:

I bought this TJ used with 186k miles on it, the guy said he had just changed the radiator out. After flushing the heater core to get it to heat up (which didn't work), I eventually found this problem. The core was full of junk and had presumably been stagnant for quite some time, but this pump didn't put up enough pressure to push water through it even after I flushed it (from both directions). I fear that it is going to spring a leak when I put the new pump on... I've seen videos of that job, and I may run screaming into the hills if I have to do it.

Seriously, though - without much of an impeller, I'm surprised the engine wasn't overheating. We don't take very long trips in it, my son just uses it as his daily driver to school and around town. Wonder if anyone has seen this? Are there any issues it might cause with cooling passages on the block not getting good flow? Am I going to see water leaks everywhere when I put the new pump on it?

Thanks in advance for any recommendations.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:34 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC