|06-22-2011 09:11 PM|
A/C Low Pressure Switch - does it have an o-ring?
The A/C refrigerant on my 1994 Wrangler Sahara (4.0L) leaked out of a rusty condenser. I replaced the condenser, accumulator/drier, and all the system's o-rings. But when it comes time to thread the low pressure switch back onto the drier, I noticed it has no seal. Is it supposed to? Did I lose it?
Under the pressure switch is a handy schrader valve which lets you change the switch without venting the system. Both are metal thread interfaces; I have a hard time believing a metal to metal seal would be sufficient. Can anyone verify if there should be an o-ring here? If so it must be custom, none in my generic kit are small enough!
Attached is a pic of the inside of the switch. The rod opens the schrader valve.
Thank you very much!
1994 Wrangler Sahara 4.0L