|06-06-2006 03:14 AM|
I just did the opposite. Bought a 95 with a blown 4 banger, and replaced it with a 2.5 from a 90.
Moved from old engine to new:
Intake & FI
Water Pump (actually bought new - cheap insurance)
Flywheel (bought new pilot/clutch/pressure plate/TO bearing)
The 95 had MPI and the 90 TBI as has been said.
The distributor from the 95 had a four-wire tail coming out of it, but the 90 didn't.
There were places for the sensors, and some appeared to be different, so to play it safe I swapped them.
The 95 was set up for a serpentine belt, so I had to use the harmonic balancer from the 95 to drive accessories. Note that the water pumps rotate in different directions between the two. The HB had to be driven back farther onto the end of the crank to make it line up with the other pulleys. It almost has to rub the timing chain cover.
The flywheel form the 95 had 4 notches on opposite sides, but the 90 had perhaps twice that number. I swapped that because I was concerned about "confusing" the computer when the crank sensor started counting them.
With those changes, it was a direct swap. I'd assume going the opposite way would work as well. No wiring changes were needed................chim
|06-05-2006 06:14 PM|
|1BLKJP||Nice, I knew some of you YJ boys would pipe up in here.|
|06-05-2006 06:13 PM|
|Hackle||WB is correct you will need a new harness if you did not get it with the 95 motor and a computer.|
|06-05-2006 05:59 PM|
|whitebuffalo||90 2.5L is fuel injected but its its TBI and the 95s were MPFI i beleive. would be different computer and electronics. i would think ud need a new wiring harness and the comp, other than that, it oughta drop right in|
|06-05-2006 04:46 PM|
|1BLKJP||The only differnce might be the difference between the Carborated and Fuel Injected. I believe your 90 would've been carb'd and the 95 should be FI.|
|06-02-2006 12:15 PM|
|bluvikng||If you are having to put in a motor, why not put a larger one in? Say a I-6, or V-6, or V-8. Or do you want to keep everything original? I would think the 95 motor would plug in just fine.|
|06-01-2006 11:35 PM|
need info on a 1990 wrangler
i just purchased a 1990 wrangler with a 2.5 that doesnt have a motor in it would a 1995 2.5 motor need any additional wiring or should it bolt and plug right in