|07-23-2011 09:31 PM|
|07-23-2011 09:23 PM|
|07-23-2011 08:40 PM|
|Gr8Northern||I would check fuel pressure an make shure you dont have a weak pump, that was the problem on my cherokee when it did the same thing.|
|07-22-2011 04:33 PM|
I've changed the plugs in mine a couple of times by removing that rail, but didn't realize that was also the coil. Will that whole long rail have to be changed if the problem is the coil/coils?
Just checked my new Haynes Manual (my old one ran from 1987-2000 which didn't show the coil rail) and got a good description of the coil rail, but that electrical connection on the end looks to be a hassle pushing and pulling everything in the right order to get it to separate. Guess things will be more clear when I actually have to remove the rail.
I had a intermittent "check engine light" within the first year or so when the Jeep was new and they changed the air pump, something on the engine I didn't see them change, the gas cap, but after over a year with the same problem they ended up dropping the gas tank and it was leaking around the cap on top. Had to replace the tank and no more problems there for over 5 years now (maybe I should be knocking on wood someplace).
|07-22-2011 01:18 AM|
|07-21-2011 11:39 PM|
|07-19-2011 12:55 AM|
|07-18-2011 12:43 PM|
Ditto a bad coil will act up after a heat soak.
Also make sure all the heat shields on the fuel rail/injectors are in place and in good shape. A hot soak rough running restart is also a sign of of vapor lock.
|07-18-2011 09:50 AM|
|07-17-2011 11:42 PM|
I have that issue too...changed plugs (stock Champ replacements) and no change.
It does it at random around town driving...start it up and sounds like it's not running on all cylinders. Rev it up or just start driving and eventually all cylinders kick in and it stays normal from there on out. It did it bad today on my way home to OH from IL...drove 133 miles non-stop. Stopped at a Pilot to take a leak and fill my tank, restarted it and it was missing bad...revved it a few times, still missing...started driving...still missing. Hit about 3500 RPMs in first gear as I headed for the exit and the other cylinders finally kicked in and stayed.
|07-17-2011 06:26 PM|
|Gorving3||Guess no one has any experience along this line or any good suggestions so probably the only solution will be the Jeep dealer. I know they have all the knowledge to fix all Jeep problems (said with tongue in cheek and trying not to laugh).|
|07-12-2011 09:50 PM|
Jeep sounds flooded upon start-up
I have a 2001 Sahara 6 cyl auto that for the last several days with temps around 100 and running the air conditioner full time when it is re-started within 30 minutes to 3 hours after shut-down the engine sounds like its missing or flooded for 10-20 seconds before it smooths out. If it was a carbureated engine I'd think the float needle was sticking or the float level was set wrong, but what can it be with the injected engine?
I thought maybe the A/C being left on at shut-down and still on at start-up might be overloading the engine but it does the same even with the A/C turned off before starting the engine.
I installed new Autolight App plugs about 1,000 miles ago replacing the Bosh that had been in for around 30,000 miles even though they weren't causing any problems. The engine seemed to run/idle smoother with the new plugs though, until the last several days.
Any thoughts or ideas?