|07-17-2011 10:37 PM|
|07-17-2011 09:46 PM|
Haha, well, I'm close to the US now, that should save a bit on the parts ;-). 35$ isn't that bad really.
@ellman, thx for the tip, it is quite dusty here at times. But how do I reset the code, just disconnect the battery?
|07-17-2011 09:42 PM|
I got that yesterday after driving through a lot of dust in the air. Reset the code and light went off, code hasnt come back. Had the same code 3 months ago, reset, and just came on yesterday after that huge amount of dust.
Just my $.02
|07-17-2011 09:41 PM|
|07-17-2011 09:38 PM|
|Rubicon2||About $35.00 or so per sensor. They were probably expensive on your 300ZX because it's an import and the parts have to come from halfway around the world.|
|07-17-2011 09:34 PM|
|Marnix||Thx for your quick reply. I'll have a look at the exhaust first, although it doesn't make a leaking sound. I'll give the wiring to the sensors a check as well. I really hope it's not the O2 sensors, because I have the feeling those are expensive (as they are on other cars, like the ones I had to replace on my 300ZX). The engine itself runs smooth, so I don't think I'm experiencing a mechanical problem.|
|07-17-2011 09:12 PM|
p2096 - post catalyst fuel trim system low limit
ENGINE MECHANICAL PROBLEM
1/2 O2 SENSOR
(K141) O2 SENSOR 1/2 SIGNAL CIRCUIT
(K299) O2 1/2 HEATER CONTROL CIRCUIT
(K904) O2 DOWNSTREAM RETURN CIRCUIT
|07-17-2011 09:03 PM|
OBDII Code 2096
Hey Fellow Jeep Owners!
Last thursday I bought my first Wrangler. Its form 2005, and for Aruba, in a quite good condition. Ofcourse there are some things to do, but nothing a bit of TLC can't take care of.
Except for 1 thing, that is the OBDII code 2096 that comes up. The story is as follows: I testdrove it, no Check Engine Light comes on. The two days after, nothing happens. And today, the CIL comes up. I checked the error code (by turning the key 3-times), which read 2096. I do not have a service manual, so I don't know what to make of this code? Does anyone have a clue what this means?
I heard the CIL comes up after fueling and not closing the cap properly, but that has a different code I believe.
Thank you in advance,