|08-03-2011 07:43 PM|
Spy, I'm in Weatherford, Tx, west of Ft. worth a bit..
|08-03-2011 01:04 AM|
|spyjeep0520||sorry i have to ask i get on via phone where are y'all located lol|
|08-01-2011 04:19 PM|
I have all the tools, air compressor, shop fan and the knowledge to get alot of it done, but when you combine 4 to 5 of us together we can get alot done while using up two bays in my shop at home..
Our big arguement was who is going to buy a bigger fridge to put all the cold drinks in, went through alot of water and gatorade a few V8's and random juices, when we were done a few beers were killed also..
It was a great day and was glad to see everyone come out..
I have a tip jar on my bench that people can donate into, and most of that money goes for more tools...
|08-01-2011 12:07 PM|
|08-01-2011 10:50 AM|
Where who what why?
I didn't get any prior info. Thanks
|08-01-2011 10:46 AM|
|danieldlg_13||Wow, and all this was done in one day?!|
|07-31-2011 04:21 PM|
|jeepers29||Wow, I'm impressed at how much y'all got done. Looks like a great time was had by all.|
|07-31-2011 09:36 AM|
We also swapped out some end caps for Ruth..
After the day was over we had done a ton of work on 6 jeeps total and a whole lotta mods!! Now lets hit the trail !!!
Thanks to everyone that made it out, ton of pizza was eating, a little guitar pickin...great times
|07-31-2011 09:32 AM|
Checking the axle ujoints...
Figuring what is next...
Had to fab and cut/weld a new stop on Ruths bumper then give it a quick paint job..
Another evap relocation..
Welded up another set of front LCA skids..and a paint job..
New JKS discos installed..
|07-31-2011 09:20 AM|
LOL!! how do you line up a track bar, just push a little..LOL!!
Fixing a ground problem..
Working with some spacers...
Relocate a evap canister..
|07-31-2011 09:08 AM|
A little grease anyone..
New poly tire rod..
|07-31-2011 09:07 AM|
Then right in the middle of all the work, somebody calls with a snake problem, so off to the rescue we ran...
Danger Danger danger as steve irwin would say LMAO!!! It was a catch and release good snake..
|07-31-2011 09:06 AM|
On Angela's jeep we relocated the steering dampner and did a evap can relocate..along with welding up some nice poly fron LCA skids..
|07-31-2011 09:03 AM|
Also did a stubby bumper in KGN's jeep, alog with a nice st of JKS quick discos..
|07-31-2011 08:58 AM|
HOLY SMOKE we did alot of work at Jeep work day VI...
I got a early start and a Eric came in on Friday night to get his Teraflex 2.5 lift kit and shocks installed.
Tony hard at work, LOL!!!!
Steve Stanley was up next with a evap relocate and a new set of horns for his jeep.
Derek brought out his jeep for ALOT of work, new Poly tie rod, replace a bent rear lower control arm, new rear bumper and tire carrier, and a new set of ground wires to make a starting problem go away..