Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Installing lower control arms. Help

Join Wrangler Forum Today


Thread: Installing lower control arms. Help Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-30-2007 08:23 PM
Triple88a Just measured my control arms.. All 4 stock lower control arms from bolt hole to bolt hole are 15 and 3/4"

Rough country fixed arms for my 00 tj are 16 1/4". All 4 arms are the same length.
09-30-2007 06:41 PM
Triple88a Ok thanks guys that makes sense i wont have enough time for one day to install my kit so i'm trying to get the easy stuff swapped in first so at the end all i have to do is the swap the springs and the shocks and be done w/ it..

I got few hours each day.. but i need the rig every day so i gotta do it piece by piece..
09-30-2007 06:38 PM
AzTJ ^ X2 - just install one at a time. unbolt from frame and axle, remove and replace.
09-30-2007 06:36 PM
mr4x4 just un bolt on control arm at a time and thats all you have to unbolt
09-30-2007 06:33 PM
Triple88a
Installing lower control arms. Help

Hello all. Any help as far as installing lower control arms is welcome

Do i have to disconnect anything but the stock lower controls arms when installing new Lower Control Arms?

Dont want to end up dropping the axle or breaking something on accident. Write up or installation instructions are welcome too

Thanks in advance

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:49 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC