Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > 93 Bellhousing Swap?

Join Wrangler Forum Today


Thread: 93 Bellhousing Swap? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-06-2011 10:22 PM
SaltyGator06 Thanks Ab...93, I kinda figured it was the same, but wanted some reassurance from a voice of experience. That internal slave is pretty useless in my humble opinion. I was planning on a new throwout and new slave, no I'm torn between buying Master/Slave combo or the custom plumbing the old master to a new slave? The master looks like it was just replaced... Oh, the decisions... any opinions?
08-06-2011 11:39 AM
Abomination93 the clutch, and pressure plate are the same, but if you ever need to replace the clutch again i recommend buying a clutch kit for a 94+ as it comes with the proper throw out bearing. from hat i read from your post you may need to get a new throw out bearing if you didnt get one with the stuff from ebay.

i did the same thing to my 93 a few years ago without any knowledge of this conversion.

just throw it all back together and run it.
08-05-2011 07:41 PM
SaltyGator06
93 Bellhousing Swap?

Hello All,

I am a newbie here, but I need some expert advice. I just bought a 93 YJ with a spun bearing. Rebuilt the 4.0 , replaced the clutuch, pressure plate, throwout bearing, pilot bearing, and installed a new slave cylinder. While I was bleeding the clutch, I heard a loud pop, all the fluid ran out of the bellhousing and the pedal wentn limp. After reading here about the perils of the internal slave, I picked up another, dopped the tranny, and replaced it. This one worked much better, it lasted 65 miles before it let go. The first one had a blown o-ring, this one is acting the same. So, thanks to eBay, I have a external slave bellhousing, fork, and a new 94 tranny from mans -tran on the way. My queustion is: Do I have to change the clutch? The brand new clutch and pressure plate have 65 miles on them. Has anyone compared the clutches of the 93 with the 94?

Thanks in advance,
John

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:30 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC