|03-05-2012 09:56 PM|
here is one
Here is one in Albuquerque. Might get it shipped reasonable... or someone going there?
says no email. but here is response on craigslist.
He parts out wranglers.
|03-05-2012 09:04 PM|
Check the salvage yards there for a 1996+ Dodge Dakota 4 cyl Not sure the last year but it is the same block.
|03-05-2012 08:43 PM|
|08-12-2011 05:43 AM|
|Wantstojeep||I am dropping a 283 SBC in my 93, new trans, axles. the 2.5 just doesn't have the power that i want. I'm doing to all for around $2000 less the cost of the jeep. (i have a 2.5 for sale LOL)|
|08-11-2011 09:10 PM|
|PaulRevere1991||find a crap grand wagoneer for like 500 and take the 360 out of that, that's what i plan on doing eventually.|
|08-11-2011 08:07 PM|
|Jarrodbeckstead||I'll be dead honest, I couldnt care less as long as its semi-affordable. Not looking to hit the rubicon trail but some balls wouldn't hurt.|
|08-11-2011 12:28 AM|
|444||What kind of engine do you want to put in? A 4.0? A 4.0 based stroker? A v8?|
|08-10-2011 10:22 PM|
Engine upgrade requirements
Hey all, blew up my 2.5 and the machine shop says cylinder walls are too thin to remanufacture. Thinking about a bigger block but was t sure what I'd need to upgrade besides the ax-5 to a ax-15 transmission and the ECM. Anyone have any info or suggestions? I was also considering swapping in a crate engine but assume I'll run into issues with the bell housing and the tranny shaft fitting into the block. If ANYONE has ANY info or suggestions I'd appreciate whatever you've got.