|11-07-2007 10:04 PM|
|TeeJay||let's see the new shin guards!|
|11-07-2007 10:02 PM|
WOW, those were really hard to fish through. After playing for more than an hour, I finally was able to get all the bolts in.
Thanks for all your help.
|11-07-2007 09:25 PM|
start by passing it through the slit turned kind of sideways. it wont fit in both at once
Start side ways in the second 'l' and fish the other end through the first '0'
then grab that end and use it to pull the remaining portion the rest of the way through that second 'l' you started in and up until it can be finagled through the second '0'
put on the rest of the stuff.
|11-07-2007 09:00 PM|
Not sure I understand TeeJay. There are 2 hole on top and 2 slits below them (see picture above). The bolts do not fit into the bottom slits. They do fit into the 2 holes, but no matter how I try, I can't seem to fish the other end around and through the holes.
Sorry if I'm slow on this, I'm just not getting it.
|11-07-2007 08:47 PM|
|TeeJay||put the short side in the long slit on the lower rear section. Finagle the thread through the hole in the front. grab the short thread and use it to fish the long end through the rear hole and place the small threaded washers on so as not to drop the silly little piece.|
|11-07-2007 08:22 PM|
|4point||Put a washer and a nut on the long side so you don't drop the bolt into the frame,insert the short side of the bolt into the first frame hole and push it over and out the other frame hole. Mind you I've never installed these so I'm guessing from your illustration.|
|11-07-2007 08:16 PM|
|sgarelick||tried that and played around for a while to get the long side to come out the other whole but I just can't get it. There must be something I'm doing wrong.|
|11-07-2007 08:12 PM|
|4point||It looks like you should stick the short side through first.|
|11-07-2007 08:08 PM|
here's a scan of the instructions.
|11-07-2007 07:57 PM|
Here are some pictures (as long as I posted them correctly)
|11-07-2007 07:41 PM|
Mopar side step installation
OK, I can't figure this out. I bought a pair of Mopar side steps for my 2004 Wrangler. It can with bolts that are shaped like this (one threaded end is longer than the other):
I see the 2 holes that the bolt is supposed to go into but can't figure out how to thread it through the holes. You somehow have to put one end in first and then fish it around so that the other end comes out the other whole. I wish I could describe this better but those of you who have installed them must know what I'm talking about.
Any thoughts on how to do this. The installation instructions make it look simple but don't say if you stick the short end in first or the long end.