|10-27-2012 12:39 PM|
|jeep-noobie||this post is pretty old but ill give it a shot ! i hydrolocked my 2.5 yj the other day, im new to this, i pulled the plugs, cleaned everything out, check all my fuild everything is fine, i have compression, gas and SPARK. but the sucker still wont turn on ! need help ASAP its my one and only car !|
|10-12-2011 01:16 AM|
|2005TJSOCAL||Ok yeah i put reg oil when i got back, ran it for 10 minutes, dumped it, changed filter, what maybe a week do it again i dont drive her that much. Ill do it though|
|10-11-2011 04:56 PM|
|sevenservices||...Im still wondering how the heck the coolent poured out from the back of the engine? Holy crap what happened to it???|
|10-11-2011 04:52 PM|
|10-11-2011 03:36 PM|
|2005TJSOCAL||I just want to say so far so good. I used marvel mystery oil in fuel and oil as well as oil change, filter, trans, diffs, even though I could not see anything in the diffs or trans. The jeep is running fine.|
|09-29-2011 11:20 PM|
I actually got it to fire up and had to pull a trailer all the way home. I have changed the oil and filter but thats it. It seems to be running good so far. I also have been running fuel cleaner every tank so far.
|09-29-2011 04:56 PM|
|justin399||I'd pull the plugs and the fuel pump relay and try and turn over the motor. Hopefully it'll blow out the water. Good luck with the head gasket.|
|09-29-2011 04:14 PM|
|09-29-2011 04:10 PM|
If all the other fluids look good, don't change them. Except the oil. Change the oil and filter.
|09-29-2011 02:18 PM|
I hydrolocked my 05 TJ last weekend. I got it towed out of the hole and pulled the plugs. Finally I got it to shoot the water out and then took intake off and cleaned. I ran gas in the intake and turned over to where I believe got everything out. I cleaned the plugs and it fired up. Is there anything else I should change? My diffs have breathers but should I change all fluids anyway? No water in oil, no water in trany but I think I have sand between the tranny and motor, and in the starter still. Thanks
|08-31-2011 07:59 PM|
|08-31-2011 07:40 AM|
That or pull the spark plugs, turn it over, spray some oil or some wd40 in the cylinder, turn it over, plut the plugs back in, check the oil to make sure it's not milky, start it back up, hope theres no damage and keep on wheeling.
But yes don't try to restart it.
|08-31-2011 01:54 AM|
If my car stalled after running it through water, I wouldn't do a dmn thing! Just let it sit there and cool down. Pop the hood a bit. Hum a tune or two.
|08-30-2011 08:51 PM|
|Troy..YJ||thank for the advise guys it looks like a head gasket or head problem thank you so much|
|08-30-2011 01:19 PM|
After your Jeep stalled from running through a deep puddle of water, you thought the best course of action was to start it and rev it???
That's a great way to bend a rod.
|08-30-2011 09:24 AM|
|dale 3||Do a compression test.Then pin point what's -ucked.|
|08-30-2011 08:02 AM|
|Dance GvN Dance||
My friend hydrolocked his 07 ranger and it revved to about 2000 and stalled and he did this over and over just to get it out, and all he did was get a rear main seal leak and he was in 3 feet of water
But it all depends
You couldve gotten water in your heads and like he said it couldve increased compression dramatically and blow some rings
|08-30-2011 07:26 AM|
|95YamJam||My guess is a popped head gasket. Adding water to the cylinder increases your compression exponetially. It's gotta go somewhere...|
|08-30-2011 02:12 AM|
|08-30-2011 02:10 AM|
|08-30-2011 01:59 AM|
|08-30-2011 01:56 AM|
|08-30-2011 01:09 AM|
|08-30-2011 01:07 AM|
when you dranied the oil do it look like milk? means water go into it
correct me if im wrong think grey smoke means a blown ring?
|08-30-2011 01:02 AM|
A....what do you mean by the "back of the engine"......is it a freeze plug.... a hole... a crack???
B....did you suck water up through your intake???? Was air filter soaked??? If not... doubt you hydro locked..... I have seen hydro lock... engine seizes INSTANTLY.....
C.....if it is turning over, I doubt anything major broke....possibly a fuel or spark issue from all the H2O.....
|08-29-2011 11:17 PM|
Jeep YJ Hydrolocked
I hit a large puddle (10ft x 8ft ) maybe two, two in a half feet deep at 25 mph (3500)rpm and my engine stalled at the end of it. I got it started and revved it up until the white/grey smoke got to a minimum, and towed it home. Now it won't start at all. I drained out all the fluids and put a solution in the oil to clean the impurities out, no leak there, but when I put new anti-freeze in it all came out the back of the engine what did I most likely break and is it gonna cost an arm and a leg?