|10-11-2011 08:33 AM|
"e-brake"="virtual reality brake" as opposed to 'real emergency brake'.....the stop-and-hold designs of olden times.
Don't understand why they do it this way now....can't be just the disc pad design.
|10-11-2011 05:51 AM|
|10-11-2011 03:03 AM|
When my auto transmission shredded itself in my Trailblazer SS it was supposed to be a three day job max and that included getting the parts they needed.
On the third day I called and asked if it was ready. The tech told me 'no', that they accidentally broke the o2 sensor in half while working on the tranny and, of course, none were in stock so it would be the next day.
Next day pick up the truck. Under customer complaints on the work order there was listed "Truck will not go forward while in gear" and also, "Customer complains that truck runs rough". I told them about the truck not being able to move but I didn't say anything about a rough running engine.
Of course "Truck will not go forward while in gear" was the kaput tranny that they had to rebuild under warranty but the "Customer complains that truck runs rough" was ALSO covered under warranty as a "bad O2 sensor". The one that they snapped in half while working on the tranny.
|10-09-2011 08:16 PM|
|Oil Eater JK||I had the same problem and fixed it myself with out removing the console completely. It was a pain in the butt doing it that way. It didn't take too long and I got it done. I ordered the replacement handle/coil part and swapped it. NOTE!!! remember to hook up the brake sensor cable! In my case the DVD wouldn't work because the brake never registered as on. May not be an issue if you don't have My Gyg. Anyways, since then I've had the brake adjusted twice and it's back to the same uselessness as it was before I snapped the first one. Apparently this is a common issue. Sucks for hooking up the trailer on a hill!|
|10-08-2011 08:45 PM|
I broke a metal piece that attaches to the lever. Have to order/get a new one through my Jeep stealership Monday. -.-
I've been told it a little over $40 and I can do it myself.
So right now I'm driving without an e-brake or a center console.
I also broke my shift boot so now the rubber is just flopping everywhere when I shift. -.-
kjeeper- I call it e-brake.. but I only use it for parking too.
|10-08-2011 06:57 PM|
Clean and adjust rear break shoes ??
|10-08-2011 06:50 PM|
|HillbillyJeeper||My 07 did the same thing. Aint even tried to fix it yet. I might do that tomorrow.|
|10-08-2011 06:41 PM|
Now that I think about it, who actually uses it as an "emergency" brake?
Some call it an e-brake and some a parking brake. Assuming they are the same.
I call it a e-brake but use it only for parking
|10-08-2011 06:16 PM|
I'd recommend not using the thing unless it's a situation where you really need it, because using it all the time runs the risk of driving across the parking lot with it on that one time, and that's all it takes for it to start losing effectiveness
|10-08-2011 05:40 PM|
I was told the PO probably did not use the
ebrake so it need adjusting ??
Whatever they did it seemed to work.
Now-- every once in a while it will still make that popping sound, I have to pull up pretty hard for it to work. I have a manual so just keep it in gear.
Researched it briefly and seems the ebrake is somewhat complicated in this thing, also-- others have had issues too.
|10-08-2011 09:59 AM|
The console will come out without taking out the driver's seat. Those seat bolts are a real pain huh? The console isn't much better but with the e-brake broken it would be much easier.
Replace your broken thingamabob and you should be good to go.
|10-08-2011 03:08 AM|
Snapped my e-brake.
Parked the Jeep, pulled the e-brake up and POP. no tension. whatsoever.
I've spent the last 3 hours trying to figure out the problem (took the driver seat out, console out, e-brake mechanism apart.. can't figure it out. I do see a broken metal er.. thingamabob? right under the lever
I googled it and saw quite a few jeepers who have had this problem - most said it is the coil but I'm not so sure.
Haven't looked underneath for loose brake cables yet.. will do that in the day light.
Anybody else have this problem?