|06-04-2012 03:04 PM|
|MichaelJ||Chris...HOW ABOUT A COUPLE OF QUICK TIPS ON GETTING TO IT. thanks|
|06-04-2012 08:19 AM|
|ChrisD65||Hi Michael and welcome to Wrangler Forum! The switch in question is the vacuum switch.It's very easy to replace.It took me 10 minutes taking my time.|
|06-04-2012 07:53 AM|
Just posted a thread about my switch losing all its levels, and finally working only on HIGH. Now that's out....then saw your message. QUESTION..is the switch a big deal to change? Thanks
|10-11-2011 11:53 AM|
Definitely the switch. Just replaced mine too, which was doing the same thing.
When the resistor pack goes, your blower will usually only work on the highest setting, which bypasses the resistor. It won't matter if you wiggle the switch.
|10-10-2011 02:40 PM|
|ChrisD65||thank you kindly!|
|10-10-2011 02:36 PM|
|10-10-2011 02:31 PM|
|ChrisD65||thank you GS00 I tried that to no avail.The blower will work on all the setting when I push up on the knob.I reckon it's the switch.|
|10-09-2011 07:30 PM|
mine was doing this. From what I gathered it canbe two things, the switch or the resistor.
I would pull the switch off, like the knob part. and then push on the rod very hard with a flat head screwdriver. put the knob back on and see if it helped.
if not you may need to replace one of the two aforementioned parts.
|10-09-2011 07:22 PM|
heater/ac switch question
good evening fellow Jeepers,I have a minor concern regarding the heater/ac switch.It only works when I wiggle the knob.Thats it!