|Today 09:07 PM|
|41MB-00TJ||Does any one know how to install a dimming switch for front fog lights. I have LED fog lights and a prewire D-box but I want to be able to SIMM them up or down. Please let me know if you have any input.|
|Today 08:31 PM|
Ordered a Barricade rear bumper and tire carrier combo from the folks at Extreme Terrain.
|Today 07:27 PM|
|Joshb||4in zone with MC arms and RE front track bar|
|Today 07:16 PM|
|Today 07:11 PM|
Lift done and Trucklites in ) some good work today
|Today 06:57 PM|
|Today 05:38 PM|
|Today 05:35 PM|
|Today 05:27 PM|
|Mamefreak||Walked out of my shop to actually get a look at the sun and saw a broken down TJ go by on a flatbed truck.... It made me sad... So I went back inside... And sadly that's all I did today|
|Today 05:11 PM|
Cleaned up some surface rust on the drivers side frame rail. Going to do the passengers side tomorrow. Looks like I'll be performing a frame swap next spring....
Idk how a tj could ever survive up here in the NE.
|Today 05:08 PM|
|Today 05:06 PM|
|Today 05:04 PM|
|Today 04:27 PM|
|RandyKyser||Sat down and wrote down all the modifications I wanted to do!!!|
|Today 03:27 PM|
|RedBaron1989||Warn M8000, Rugged Ridge SRC bumper, Rugged Ridge 7" fender flares. And put the hard top back on for winter.|
|Today 02:15 PM|
|Today 01:09 PM|
Coated (internally) my new 'safe-t-cap' rails. I used this Eastwood stuff last year, before replacing the metal. Unfortunately, it didn't save the steel that was already corroded.....honestly, it was wishful thinking. Applied to fresh, clean steel is better than nothing. I plan on a second coat of 2 more cans. AFTER it cures, I'm coating the entire (inside & out) frame with FLUID FILM.
No slacking this year. NE salt and snow are murderous to our Jeeps.
|Today 11:09 AM|
|Today 11:01 AM|
|41MB-00TJ||The front and rear XRC bumpers. I installed the front bumper. But I have to get the rear bumper replace because powder coating was not finished|
|Today 10:57 AM|
|41MB-00TJ||Well year era when I got home I saw that brown Santa stopped by and left me these|
|Today 10:49 AM|
|Today 09:50 AM|
Well not today.Took a lot of buying and selling to get the LOOK i wanted.
17''rims to 15''s.Nitto AT'S to Goodyear Wranglers.No mud so stayed with CHROME.6''flares to sahara,rubi width.
Added obsolete sahara running board and fairhead plate cover.
|Today 04:56 AM|
It's not fun. I broke all four of mine about a month ago. buy plenty of cut off wheels. When you're done, just use some 1/4 20's with flat washers and lock nut. I had to "customize" a wrench so I could get a hold of the locknuts.
|Yesterday 08:44 PM|
Speedo Gear swap
My new to me TJ was going faster than indicated according to my GPS. I read up on WF about cause and fix right here on WF. I ordered a new correct 31 tooth gear and fresh O-ring from Quadratec for $38 and had it the next day ground.
Found the ratio while searching for reasons for incorrect speedometer readings. Figure it had to do with 33" tires PO put on. Took about 12 minutes as I had to get up off the ground twice to get a pick tool to pull the oring off and a can of brake clean to clean up the little bit of fluid that came out when I pulled the stock gear out of the TC. Now the MPH is spot on. My fuel mileage will be accurate now and service interval will be correct. Don't hesitate to do this simple mod. 1/4 drive ratchet, 1/2" socket, brake clean, new o-ring, rubber gloves, pick tool to get o-ring off.
There is video here
Link to job.
Changing Your Jeep Speedometer Gear
LOVE MY TJ!
|Yesterday 08:34 PM|
I rotated tires.
Took the rear shaft off the tail of the transfer case to check the torque on the yoke nut and while manipulating the front DC joint noticed that it has a bit of a notchy spot in it. Since its a relatively new shaft I'm going to call the shop I bought it from and see if they'll replace it. Since I think that's what's causing my 65mph vibration.
|Yesterday 08:31 PM|
|Yesterday 07:28 PM|
On topic: I just drove it around doing Dad stuff. Ahhhhh....... but look what came in the mail today. The last part of my new steering set up.
|Yesterday 07:00 PM|
|Howlie||Installed rugged ridge cb mount|
|Yesterday 06:51 PM|
Installed a rampage full enclosure top. Body armor rear bumper with swing out tire carrier.
Check the link below to see my build with pics!!
|Yesterday 05:19 PM|
|This thread has more than 30 replies. Click here to review the whole thread.|