|11-07-2011 06:43 AM|
|draarong2004||if you have any white lightning grease or can buy a small tub of it, get it and try putting that on first. it'll help seal it but also make it so you can get it back off if you need to, you can use this instead of rtv or the like if you don't have any majore leaking issues, i just used rtv on mine because i didn't plan on taking them off the new radiator again...or the block, if i do, i might be able to get it back off.|
|11-06-2011 08:28 PM|
Franklin3-- I'll check into the spring deal...the old one I took off did not have one on it but that doesn't say anything... Whoever wrenched on this thing before I bought it...eek! I have found some shotty work so far...not good.
UPDATE-- replaced flex hose with new hose and clamps as well...still freaking leaking! This makes my mechanical skills look bad! I think it's worse than before...I am left to believe that it is my water pump... I have not put sealer on yet and may not... I gotta take it in and have it looked at cuz its my daily driver and can't have it break too bad!
|11-06-2011 06:47 PM|
|Franklin3||The lower hose has a spring in it. My pump went out on me after doing a flush so I decided to change hoses while I was replacing pump. Still had the stock ones on. The only place I could find one with a spring was the stealership. I was told you should get it because it might close up from pressure and cause overheating.|
|11-06-2011 11:18 AM|
|Ytread||Dra, I know what you're saying... I'm thinking the only reason it's leaking now is because it finally rained here and it's nice and muddy now that the Jeep is garaged!|
|11-06-2011 02:21 AM|
|draarong2004||its a neverending battle with any vehicle, but i fix everything i can as fast as i can, and so far i don't have any new leaks yet, i'm sure somethings going to leak tomorrow while wheeling though...lol|
|11-06-2011 01:33 AM|
Keybler No wiggle in the fan.. leading me to believe that it's not the water pump failing but possibly could be a crack in the neck... all clamps are the screw on, that's the first thing that I do with a vehicle because the clamp ones are rediculous!!! BUT they are not brand new so could be an issue...
draarong2004 I did not put any sealant around either the water pump nor the hose... I'll give it a shot in the morning though... nice going on your end though! No leaks are good!
Thanks to both of your responses, I really appreciate it. I'm gonna give it another run and see where I am... gotta get it back up by Monday!
|11-06-2011 01:13 AM|
also did you put any sealant between the hose and the water pump? in any repair manual it recomends blue rtv or equiv to help seal it up better, i had to do this when i replaced my radiator in my jeep recently, no matter how i clamped it down it still leaked a lil around brand new hoses and brand new radiator, now it doesn't leak ANYWHERE.
|11-05-2011 11:07 PM|
Can you wiggle your fan attached to the water pump? I had a similar problem and replaced all hoses. It ended up being the pump. It was leaking from behind the pump pulley and dripping down the hose. You can get a water pump and all hoses from advanced auto.com for under 100 bucks.
Also replace stock hose clamps with the type you screw on. The old ones can wear down, or so I've been told.
|11-05-2011 10:29 PM|
is it my water pump neck or clamp issues?
I have a 1992 Jeep YJ as a daily driver and right now it sits in the garage with a big green pool underneath of it...(sigh). I was heading home the other night and my heater wasn't blowing any hot air... the next morning checked the coolant level and was super low. After a quick refill drove around town a few days and checked it later and it was low again. So I crawled my lazy underneath and noticed that my lower radiator hose was leaking from the water pump end. Removed the hose and found that it had a tear inside where I assumed the water was traveling through and thus causing the leak. no one in town had the proper hose so I bought a flex hose instead. Attached hose and refilled the radiator again, started up and crawled back down to check for leak... small leak coming from the inside part... looks like it is leaving the water pump neck and forced up between the neck and hose and out...very small drip but continuous... all in all what I thought was going to be a quick replacement and solution is still my problem... possibly worse than before. Not sure if it is the clamp, hose, or water pump... or simply I am just an idiot and overlooking something? Any suggestions? Thanks in advance!