|04-16-2012 10:56 PM|
|04-16-2012 10:47 PM|
well we bought a compression tester... and it was like around 60 on the first 3 and 90 on the last one... my book says its supposed to be around 180... holy hell it was off. i had to wait till i had the funds and i bought another engine. i ordered one from engine and transmission world... used, supposed to have around 80k on it. about a 20 day process. put the new engine in.... and it has been so far so good for now...
|12-05-2011 03:10 PM|
|Garyk||Could be a blown head gasket. Check the plugs too, see if any are wet or black.|
|12-04-2011 10:57 AM|
|Irongrave||drain your oil and see what it looks like and work from there|
|12-04-2011 10:49 AM|
|vikessoftball||well it turns out... i had to replace the computer. i got an electrician from the coast guard to check it out and he eliminated every possible cause. so i ordered the computer, plugged it up and it cranked right up... i'll be damned. i was driving it for about 2 weeks and it was leaking oil. located the source of the leak and it turns out the valve cover was cracked on the right side. so i let it sit a couple days, replaced the valve cover, and then went to crank it up yesterday and the engine sounded terrible... like it was so weak. i checked the oil and there was a white foamy substance... this is when water mixes with the oil correct?? what could be the possible source of this? is my engine blown?|
|09-27-2011 12:59 PM|
|UABYJ94||Did you make sure the ground wire was making a solid contact with metal and no corrosion or rust inhibiting continuity? If yes then ohm out the wires to the fuel pump to make sure they are good,not broken, and getting proper voltage. Ofcourse this is only after you have verified a working relay has been installed.|
|09-27-2011 12:47 PM|
|vikessoftball||Okay.. So today. I swapped out the fuel pump relay with which ever one was underneath it. Still nothing... I'm assuming that my horn relay is broke since it doesn't work so I don't know if I should still switch it out.. I ordered a starter and its gonna be here tomorrow. I check the wires near the pump and they all look in good shape. Didn't see any corrosion or breaking. Also check the ground wire. Its bolted into a piece of metal near the parking break. Is that normal?? And I also tested the pump on the battery... It works... And so does the other one. Go figure... I'm going to go buy a new fuel pump relay tomorrow. Anything else I should try... If the relay doesn't fix it.. What's next???|
|09-27-2011 10:09 AM|
|UABYJ94||I just posted this same test in another thread. Check the ground wire that is connected at the E-brake assy. This is the ground for the fuel pump and may have broken or come loose.|
|09-26-2011 10:24 PM|
|DamnBigPapa||Keep in mind that if you turn the key to run ... The pump is only supplied power fir a second or two. Then apllies powet continuous when cranking and running. Swap the relay with the horn relay (same) and see if it makes a difference. Again if you out a test light on thee connector near the tank it only has power when cranking it running. A buddy of mine chased wires all day making that mistake|
|09-26-2011 04:04 PM|
|Jeep716||Bench test the pump with a battery to confirm it works. Test for power on with test light on jeep where pump plugs in. Check fuses and fuel pump relay too. Good luck.|
|09-26-2011 04:00 PM|
|Driller||sometimes the wiring harness pins that plug together just near the drivers rear wheel area near the gas tank will push out and not make contact when you push both together. check and see if the end fron the pump side has the female contacts are fully seated, if not push them in completely so you can see the ends on the other side and put the little silicone oval shaped plug back in and maybe even tape it so it won't slide out. this is a problem I just had with mine and this fixed it. good luck, Driller|
|09-26-2011 03:51 PM|
No power to the fuel pump
i recently purchased a 1990 wrangler off of craigslist. the seller told me all it need was fuel pump so i purchased one and then went to pick it. i live neat the outer banks and drove all the way up to maryland to pick it up and drive it back. took me five damn hours. so when i got there, me and my dad gave it the look over and he had the audacity to say that he was a mechanic and he diagnosed it himself and it just needed the fuel pump replaced.
needless to say.. we brought it home. it has been sitting in the yard for the passed week. me and my dad were gonna put the fuel pump in ourselves but we had to wait till sunday, yesterday, cause thats the only time he had off. so we pushed it into the garage. dropped the tank, drained the fuel, replaces the pump, put it bank it and reconnected all the hoses and wires. then i gave it a fresh tune up (changed the oil, air filter, spark plugs, spark plug wires, fuel filter.)
we went to start her up and nothing.... just kept turning over and over. my dad poured some gas into the carb and it tried to catch but it wouldnt. there is/was no fuel getting to the engine. he kept going and eventually the starter went out so i have to replace that.
but my issue is... i read somewhere that the fuel pump turns on as soon as you turn the key without turning it over. i turn the key and nothing... the fuel pump is not kicking in... what do i do next?????