Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > 93 starter and steering column

Join Wrangler Forum Today


Thread: 93 starter and steering column Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-05-2011 05:04 PM
mcseang ok disassembly is sorta the same on non tilt, remove the wheel, lock plate and directional switch. then remove the lock housing, i think it is 8 mm bolts. again i presume it is the rack that is broken, nonetheless it is driven by the gear you purchased. the gear does have to be timed in sequence with the gear. just spend a few minutes to get familar with how it all works before you take it apart. it is not hard to do but does require patience and understanding of how it works. it will all make sence to you if you study it before you take it apart.
12-05-2011 09:16 AM
EthanH Sorry i should have specified that it is a non-tilt. i do not have the tilt function.
12-03-2011 08:52 PM
mcseang i have rebuilt plenty, but have not seen the gear go bad very often. more times than not it is the rack that breaks. is your column tilt or or non tilt? anyway all you have to do is remove the wheel then the locking plate that is held in with a snap ring. there is a depresser made for that purpose but it can be done with out one using an awl or ice pick to unlock the retaining ring. next remove the directional switch, then use a # 20 torx to remove the lock cyl. then i think 3 # 30 torx to remove the lock housing. this is the way to do a tilting column... once the housing is off you will see the gear, simply use a flat screwdriver to pry it off the shaft and slide the new one on. if you have a non tilt it will be different. but again my guess would be the rack has broken
12-03-2011 05:25 PM
EthanH
93 starter and steering column

i have a 1993 jeep wrangler. the sector gear behind the ignition lock cylinder has been stripped. i bought a new one but i cant figure out how to dismantle the steering column to replace this part. please help. thank you.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:02 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC