|12-10-2011 10:42 PM|
|12-10-2011 10:39 PM|
|12-10-2011 10:35 PM|
|darkproximity||an older head wont wont bolt up to that block.. plus the cam profile in the newer block is different and is meant for the crappy head.. also again the motor mounts are very different on the 2000+ blocks.. wont line up correctly..|
|12-10-2011 10:28 PM|
|ClayL||I could always buy the transmissions and t-case and try and find an older 4.0 head|
|12-10-2011 10:25 PM|
|12-10-2011 10:03 PM|
|darkproximity||Clay.. don't get the 00 4.0.. craptastic head on it and the motor mounts are in a different location..|
|12-10-2011 09:41 PM|
You don't have to go through all of that. Call up NOVAK. They make bushing that will fit your application. All you should have to do it swap out the bushing. It is simple. You may have to check the length of your input shaft to the old one. The new one may have to be cut down, but you can do this yourself with a hack saw and a good file. This has been done by others on this forum and the Jeep Forum.
|12-10-2011 02:59 PM|
|ClayL||think a 4.0 with ax-15 and trans case out of a 2000 will drop into my 87 and bolt up with everything fine?|
|12-10-2011 02:56 PM|
|YJ880||Looks like if you want to replace it your going to have to spend quite a bit. Might as well rebuild the one you have or find another one thats the same year. Well Im glad I did the research instead of buying it. It was a sweet deal to. I guess to good to be true. :/|
|12-10-2011 08:52 AM|
|Nubby55||I think I'd be checking to see if the pilot bearing in the chrank can be changed, be a lot less work and less money.|
|12-10-2011 01:36 AM|
91 to 92 AX 15 4WD trans swap ***KNOWLEDGE NEEDED***
1988 to 1991 AX15 input shafts have a smaller (~19/32") pilot tip. 1992-1999 AX15's have a larger (~3/4") pilot tip.
I was thinking about buying a trans off a 91 YJ AX 15 4WD tomarrow to put in my 92 YJ until I found this out! Can input shafts be changed or what???