|02-02-2008 03:51 PM|
|4Jeepn||You should not have any loose nuts bolts or the like either.. Get that fixed as well. I don't have a steering stabilzer. I did have DW, did the self align, but still needed to have the tires balanced. Which was the final step for me.|
|02-02-2008 02:39 PM|
|02-02-2008 11:26 AM|
|Triple88a||So i gues you lost a weight while spinning tires|
|02-02-2008 02:00 AM|
I went mudding last week and this week the death wobble was insane. I couldn't go over 30mph.
Got the tires balanced ($10 each tire) and VUA LA!!!
I'm back in the rodeo baby and my Jeep isn't trying to buck me off anymore.
|02-01-2008 10:54 PM|
|Triple88a||I just did the alignment using 4x4s instructions. I went to a shop since i did not have a pipe wrench strong enough to spin my rusty tie rod but it was easy. Make sure you have some one to help you hold the measuring tape though. My toe was 1" difference. Distance in front of the front tire was 1" less than the distance in the back of the front tire.|
|02-01-2008 10:03 PM|
If you can follow those simple instructions you can align it yourself. Mines running 33's on a 3" Full Traction lift. It has never seen an alignment shop and drives straight and smooth at 80. Tires wear is also very good 39K so far on Mickey Thompson MTZ's.
It helps to have a friend hold the tape measure though.
Try it out before paying the shop. Worst case is you cant do it and you end up taking it to a shop. Which you were already going to do anyhow.
|02-01-2008 09:52 PM|
|hemmer||ive never aligned anything before but that doesnt look too hard. so i take it i would only need to align the front? and should i attempt aligning it myself or would it be better to just take it in and pay to have it done?|
|02-01-2008 09:32 PM|
I would check the alignment. It's really easy to do your own alignment on a Jeep. Here is a couple links
|02-01-2008 09:31 PM|
|hemmer||alright thanks for the help and ill make sure to try and get that done on sunday or hopefully after work on saturday.|
|02-01-2008 09:25 PM|
Also if your steering is setup properly you probably don't even need a steering stabilizer. Steering stabilizers are just masking your problem.
|02-01-2008 09:20 PM|
|hemmer||no i did not i called a few shops and they told me just to get a steering stabilizer.|
|02-01-2008 09:18 PM|
|Scout||Did you do an alignment after you installed the BB?|
|02-01-2008 09:17 PM|
another death wobble thread after budget boost
after my 2 inch budget boost my death wobble got noticeable.
i got a new monroe steering stabilizer and it fixed it for a while. but now its back.
my track bar looks fine and is tight. but should i be able to rotate my drag link by hand??? also the drag link has the grease zirc broken off down where it connects to the spindle i believe is what that is.
could that be causing the wobble?
and also where the tie rod connects to the (spindle?) for the driver side wheel the nut that holds that on is loose and it doesnt tighten anymore. is it supposed to do that?