|01-11-2012 08:12 PM|
|haroldpo6||The engine looks very clean so i got it. After doing some more checking i see the block, head, crank all have different cast numbers than the 95. Does anyone know the difference? I read on one site the head has less flow than a 95. Also a rebuild kit is not the same for a 95. The 96 cost more than a 95.|
|01-11-2012 10:37 AM|
|haroldpo6||Thanks, going up this evening to look @ it.|
|01-11-2012 10:18 AM|
|Ibuildembig||Basically you need to use the longblock off the GC and everything else off yours. All your brackets, pulleys, etc|
|01-11-2012 10:14 AM|
He said everything comes the the engine except the injectors.
Grand Ck was rolled.
|01-11-2012 09:44 AM|
|01-11-2012 09:39 AM|
|banks316||Use your intake, and header. Plus the acressories from your motor and your good.|
|01-11-2012 09:31 AM|
I have a 95 I6 w/5spd wrangler w/200,000 miles that has some lower end noise, mains i think or piston slap. Anyway i can buy a 96 I6 w/auto out of a grand ck w/86,000 miles for $250 w/out trans. Will this engine be a simple swap? Anything i will need or have to change? Thanks