Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Problem with doors

Join Wrangler Forum Today


Thread: Problem with doors Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-12-2008 09:55 PM
hmenker
Door Hinges

I agree with everyone regarding the PB Blaster and WD40 but, since I live in the mountains with plenty of snow and road salt, the doors are on over the winter and can be sticking pretty badly by spring. I slap a fair amount of white lithium grease on the door bolts before putting the doors back on and it works well. The doors come off easily in the spring. In fact, I just go ahead and keep the grease on all the time and have no rust buildup at all.
02-12-2008 10:05 AM
UNLIMITLESS I cleaned the hinge with a pipe cleaner soaked in PBlaster and used some sand paper to clean the pins off. The first time you take them offSoak them with some kind of oil and swing the door all the way forward and back.
p.s. Dont jack on the outer lip of the door!
02-12-2008 12:36 AM
Triple88a 2x on taking off the passenger door, its because its obviously not use as much as the drivers door so the hinges are all tight, What i did was open it and then with my left hand lift it up and rock it in and out with my right hand as i was lifting (use a beach towel or something for your left hand so you dont hurt your hand). It took me about 5 minutes to get the passenger door off but it worked. Once you have it off use a bit of sand paper and just clean the bolts up a bit to make them a bit smaller. If you have full steel doors make sure you lower your windows so you don't damage them on accident.
02-11-2008 10:55 PM
m8094538 my passenger door gives me trouble like that. the top pin is alittle bent from sumone who owned it b4 me just gotta use force and make sure the holes r lined up with the pins when puttin them back on
02-11-2008 10:43 PM
chezuki I don't think my doors had ever been off on my 95 when I got it last year. I used a 2x4 and a floor jack to pop them out the first time. I put a dab of white lithium grease on the pins and can still take them off one handed with ease.
02-11-2008 09:39 PM
nicolas-eric i had the same problem.
i put a block of wood under the opened door and then two buddies went on my sidesteps and then the door comes off.
after that i sprayed the 2 bolts with WD40 bfore i put the door on again. now i can remove it always without any problems.
02-11-2008 09:09 PM
no_limits_jeep thanks guys I will try that tommorrow. I might have to use a jack to get the doors off but Ill see thanks anyways
02-11-2008 09:06 PM
distortedtj WD40 or PB blaster the hell out of the door pins. when you go to pick them up work the door left to right helps some. as far as you passager door: sounds like the bolt is stripped. you can try to put vise grips on the nut and push down torward the ground as you turn it : it may grab the thread and come off /also take the bottom nut off try having someone pick up on the door so the nut has force against it ;it may come off then ///if not you may have to cut it off.

once you get the doors off clean the pins off and the pin holes out Keep them lubricated and they shouldn't give you any problem.

02-11-2008 09:05 PM
Rawkon you can try wrapping a big ass flat blade screwdriver, or pry bar with a towel. with the door partially open stick the towel/screwdriver..prybar between the bottom of the door and the door sill. pry up and it should pop. my doors the first time off felt like they where welded on too. just make sure someone or you can hold the door while you pry up. you dont want it to fall off.
02-11-2008 09:01 PM
orange05tj yeah, I have the same prob with mine. Just gotta man handle them. They'll come off. oh yeah, if you get the nut off, dont put them back on. you wont be needing them.
02-11-2008 08:58 PM
no_limits_jeep
Problem with doors

My problem is that I can get both nuts in the driver door off but then I cant get the door to come out of the hinges. Am I doing something wrong. Then on the passanger door the top hinge nut I cant get loose it just spins and spins the problem with it is the bolt head is nut spinning. How so you get the doors off?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:43 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC