Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Gas Tank tuck? or options

Join Wrangler Forum Today


Thread: Gas Tank tuck? or options Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-19-2012 07:26 PM
BLK00TJ A trick I learned from an attendant is to rock the Jeep back and forth a few times to burp out some air allowing more gas to go in. I'm not positive whether it actually works, but I do that every once in a while so I can pump to a round dollar amount. I don't have to do it as often now that gas prices are much higher.
01-19-2012 06:24 PM
somis I can squeeze 17 into my 97 if I just keep squirting little by little but I like the idea of tilting it on the curb!
01-19-2012 06:12 PM
ou812 Thats a sexy Jeep

Quote:
Originally Posted by Imped View Post
Find the body lift.




I ran the Rokmen skid for a long time. While it's a very beefy skid, it's also heavy and doesn't fit the tank nearly as tight as the Savvy skid, which takes up valuable clearance where it's so tight back there. The Savvy also tucks a little higher. I don't run a Savvy (fuel cell) but have compared the two side by side. The Savvy hugs the tank to the point that it's an interference fit. It's as high-clearance and light as you'll get.
01-19-2012 01:18 PM
Abnmarine
Quote:
Originally Posted by DaisyCutter View Post
Park it with the driver side tires elevated on the curb with the fuel pump.


It'll tilt your tank so the filler is the highest point.


You may get some stares...

Since I fill up on the military base over here I'm sure I'd draw some attention.
01-19-2012 11:32 AM
DaisyCutter
Quote:
Originally Posted by Abnmarine View Post
Curious of the vent tube issue since I have a 1998 and never get more than 14 gallons in. Is there a fix?
Park it with the driver side tires elevated on the curb with the fuel pump.


It'll tilt your tank so the filler is the highest point.


You may get some stares...

01-19-2012 06:52 AM
Imped
Quote:
Originally Posted by subtlez28 View Post
In a perfect world, I would like to build my Jeep w/out a body lift.
Find the body lift.


Quote:
Originally Posted by LiftedTj View Post
x2 on Rokmen skid plate. you dont need a BL to run it, you will have to get the spacer kit unfortunately. although its cheaper than a body lift, and you might be able to get away without changing out the front 3 bolts, and only using the rear spacers from the kit.
I ran the Rokmen skid for a long time. While it's a very beefy skid, it's also heavy and doesn't fit the tank nearly as tight as the Savvy skid, which takes up valuable clearance where it's so tight back there. The Savvy also tucks a little higher. I don't run a Savvy (fuel cell) but have compared the two side by side. The Savvy hugs the tank to the point that it's an interference fit. It's as high-clearance and light as you'll get.
01-19-2012 05:28 AM
LiftedTj x2 on Rokmen skid plate. you dont need a BL to run it, you will have to get the spacer kit unfortunately. although its cheaper than a body lift, and you might be able to get away without changing out the front 3 bolts, and only using the rear spacers from the kit.
01-18-2012 07:17 PM
subtlez28 In a perfect world, I would like to build my Jeep w/out a body lift. However, the clearance gained by a tummy tuck and gas tank tuck makes it a reasonable compromise.

Plus, with just a 1.25" BL, you can clear 33"s.

My $.02 is just do the 1.25" BL and Savvy tank skid. You will not regret it. It doesn't look bad like a 3" BL IMHO.
01-18-2012 06:55 PM
doclouie I just ordered my Savvy gas tank skid. It can be used with a BL or without. With a BL it will clear just under 2" and without a BL it is like 5/8"-3/4".
01-18-2012 06:43 PM
Abnmarine
Quote:
Originally Posted by C.L. View Post
Hah, nice! Unfortunately the vent tube restriction is on the TOP end, if that makes sense. So a gas station pump shuts off after putting 14 gallons into an EMPTY tank because it thinks it's full. People have reported success dropping the tank and cutting a few inches off the dip tube. That means the level in the tank gets higher before the station pump thinks it's full. If you cut it too high though, the pump won't have time to turn off before you get a gas bath...
Thanks for explaining it. I might try to remove some of it.
01-18-2012 05:37 PM
mtbrider I'm wondering about this also. My build sheet says I have the 19 gallon tank, but i'm on dead empty after 14 gallons. I ignored it one day only to get a little spooked when going up a steep road from a light. I got some hesitation, which made me think I was closer to being out than expected. Of course after my visit to the gas station I only got maybe 14.25 in the tank.
01-18-2012 05:33 PM
TJspeed When my low gas light comes on in my 2000 i fill up right after that and i ALWAYS end up putting 15 gal in. so 4 gal as a "reserve" seems right. if you ran it dry you could get 19 gal in
01-18-2012 05:29 PM
Wesboy After installing a 1" BL and Savvy GTS, I got an extra 1.75" clearance under the tank.

I'm sure it's easier to do than trying to fit a tank from another auto.
01-18-2012 05:28 PM
ou812 Ive read that you can remove the fuel pump to allow your hand and a pvc tube cutter in the tank to snip some off that vent tube.It allows more fuel to enter the tank before shutting
01-18-2012 12:01 PM
C.L.
Quote:
Originally Posted by Peepers View Post
Drive farther before filling your tank?
Hah, nice! Unfortunately the vent tube restriction is on the TOP end, if that makes sense. So a gas station pump shuts off after putting 14 gallons into an EMPTY tank because it thinks it's full. People have reported success dropping the tank and cutting a few inches off the dip tube. That means the level in the tank gets higher before the station pump thinks it's full. If you cut it too high though, the pump won't have time to turn off before you get a gas bath...
01-18-2012 11:57 AM
freeskier
Quote:
Originally Posted by Abnmarine
Curious of the vent tube issue since I have a 1998 and never get more than 14 gallons in. Is there a fix?
Are you filling up when the light turns on?
01-18-2012 11:39 AM
Abnmarine
Quote:
Originally Posted by Peepers View Post
Drive farther before filling your tank?
I thought I read something about making a change to the vent tube to pump more fuel.
01-18-2012 11:26 AM
Peepers
Quote:
Originally Posted by Abnmarine View Post
Curious of the vent tube issue since I have a 1998 and never get more than 14 gallons in. Is there a fix?
Drive farther before filling your tank?
01-18-2012 11:11 AM
Abnmarine Curious of the vent tube issue since I have a 1998 and never get more than 14 gallons in. Is there a fix?
01-18-2012 10:54 AM
Imped The tanks are the same size. You CAN tuck the tank up higher without a body lift. Your constraining factor is the crossmember that the front lip of the gas tank skid bolts up to. The front upper bend in the gas tank will hit that and that's as far as you can go. Whether that or the gas lines/fuel pump against the tub becomes your constraint first, it's a close call. A body lift simply lifts the tub up further so that the crossmember becomes the only constraint. Your best bet is to do a 1 or 1.25" body lift and the Savvy gas tank skid. It fits the tank like a glove and lifts it as high as you're gonna get without redoing the crossmember.
01-18-2012 10:37 AM
Cons_Table I have heard different things on the 19/15 gallon thing, so I am not for sure.

I have gone with an aftermarket skid plate from Rokmen which increases the clearance under the tank. It does require a body lift to do this, but only of an inch. I havent heard of swapping in a different tank, although I am sure its not impossible. Your easiest solution would probably be the installation of a 1" body lift and an aftermarket skid. I know for sure Savvy and Rokmen gas tank skids raise the tank for more clearance. I am sure other companies do this, but I dont know of them off the top of my head.
01-18-2012 10:22 AM
ou812
Gas Tank tuck? or options

So besides a fuel cell....


I hear that the 98 sport has a 19 gallon tank but because of the vent tube it only allows you to put in 15 gallons.Is that true?

Is there a shorter tank avalible that will give more under tank clearance?

I looked at raising the tank higher but that doesnt seem to be an option without a body lift.

has anyone used a tank for a diffrent automobile that gave more clearance?


My factory metal tank gaurd is bent and so Is the tank.Id be happy with a 12 gallon tank and a non accurate fuel gauge

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:04 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC