Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > need help

Join Wrangler Forum Today

Thread: need help Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-22-2012 12:24 PM
peterbiltjunkie did you seat them and then adjust them out 3/16'' ?
01-21-2012 11:24 PM
Nubby55 I put mine at about 3/16" set timing with vac. disconnected @ 10* BTDC then adjust the carb.
01-21-2012 03:10 PM
peterbiltjunkie set timing at 12 degrees but just cant get i to even out I dont know if maybe fuel mix is off or what. What is good position for needles
01-20-2012 11:17 PM
RednekYJ Whats your timing at? I think stock it's 8degrees and when you nutter it you need to be at 11-12
01-20-2012 11:11 PM
need help

engine would idle smooth before nutter but would fall on its face at nything beyond 2000 rpms. i nuttered it and now i cant even get it to idle smoothly. starts hard and runs like sh#?! any ideas where i went wrong? thanks in advance

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 04:04 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC