Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Knocking noise

Join Wrangler Forum Today


Thread: Knocking noise Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-27-2012 09:26 PM
jay_in_cgohio For what it cost I would just change them both out. The part was 89 dollars at oreilys auto parts. I knew it was bad cause when I would press on the brake I could hear a strong air sound coming from where the booster is located. SImple test to check your is start the engine, let it run for a minute or so. Do not touch the brake during this time. Turn the engine off, again...dont touch the brake. After the engine has stopped press the brake. Did you hear air? If so chances are it is the booster. Now go to the booster and pull the check valve out. Any air or suction sound? If not then your booster is bad. Replace booster and at that price get a new master cylinder with it.
01-27-2012 08:57 PM
kboles89 The diaphragm in the booster breaks causing a vacuum leak that raises the idle. When you take it off to it over and see if brake fluid comes out the master cylinder side. If it does change the master also. Brake fluid is what usually causes the diaphragm to break in the first place.
01-27-2012 08:17 PM
Jay94YJ
Quote:
Originally Posted by jay_in_cgohio View Post
My 89 2.5 5-speed has developed a knocking noise. I only hear it inside the vehicle, loudest just in front of the gear shifter. Only does it at a idle after warm and the sound goes away if I release the clutch a little and put some resistance on the drive line.

Any clues where to start looking? Recently I have changed the oil, brake booster (which makes it idle much better and quiter, so perhaps the noise has always been there, just able to hear it now), and changed the rear diff lube.

Thanks
What was wrong with your brake booster? Mine is causing my engine to increase idle about 400rpm when I push on the brake.
01-27-2012 11:59 AM
dmblair Throw out bearing for sure. Depending upon how loud/bad it is, you should be alright for quite some time. Had an s-10 that did the exact same thing. Think I put 40,000 miles on it after the noise first started!
01-27-2012 11:11 AM
jay_in_cgohio I dont see how it could be a u-joint since it only makes the noise when I am sitting still. It is a 5 speed so there should not be any pressure on the joint when I am sitting still at a idle. As for rod knock I hope not. A engine rebuild is just not in the cards right now.
01-27-2012 12:02 AM
anamorph
Tips from the Beas

Sounds to me like the U-joint of the front drive shaft closest to the transfer case may be bad. It can also be a rod bearing. To see if it is a rod bearing, pop the hood and have the wife, girlfriend, or even the dog put a foot on the brake, pull it into gear and give it some gas. You should hear a low end knock. May be a lifter collapse too. If the sound is comming from the engine, it could be just about anything and you will need to pull the motor and open it up. You did replace the pump and the noise quietened a bit, so I really can't say, because you actually have added more vacume to the motor and there is a little more pull on all intake and exhaust parts. I would start with a U-joint.

"the GRINCH"
01-25-2012 05:59 PM
jay_in_cgohio If the weather plays nice this weekend I plan on getting it up on jack stands to change out the front diff fluid. Will be a good time to look and see what I can find
01-25-2012 05:37 PM
Garyk You might also check underneath, could be exhaust or drivetrain hitting something if you only hear it at idle and then can make it go away.....may have a broken motor mount
Could also be loose bolt on flywheel??
01-25-2012 04:15 PM
Rusty jeep my wifes 95 YJ does the same thing. I am going to go ahead and replace clutch, throw out bearing, and p plate while im in there. Ive found over the years that once your in there you might as well replace it all. so you dont have to pull the trans twice.
01-25-2012 04:05 PM
jay_in_cgohio Kinda what I was thinking but the clutch feels great.
01-25-2012 03:09 PM
Garyk Almost sounds like it could be related to the throwout bearing or clutch..
01-25-2012 07:51 AM
jay_in_cgohio
Knocking noise

My 89 2.5 5-speed has developed a knocking noise. I only hear it inside the vehicle, loudest just in front of the gear shifter. Only does it at a idle after warm and the sound goes away if I release the clutch a little and put some resistance on the drive line.

Any clues where to start looking? Recently I have changed the oil, brake booster (which makes it idle much better and quiter, so perhaps the noise has always been there, just able to hear it now), and changed the rear diff lube.

Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:14 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC