|04-10-2014 03:07 PM|
|04-10-2014 03:02 PM|
|Z-man||Stuffed 2014 Rubicon Unlimited X today.. Slight improvement for me in soundbar and sub box. Man do the speakers in the sound bar suck. I thought I paid for the upgraded system.|
|04-10-2014 09:35 AM|
Here is a link, and it uses a pillow.
Wrangler Sound Bar Tech - YouTube
|04-10-2014 09:33 AM|
|04-10-2014 12:14 AM|
So think of it like this the stock sub enclosure is .3 cubic feet so it'd need about a 1/3 of a pound at the higher end.
Here is a great link that provides information on what it should do and why
A technical understanding of Polyfill - Technical Info & How To's - SSA Car Audio Forum
There's also videos on youtube that show how to correctly place it within an enclosure.
That being said. Sound damping is the way to go when trying to get rid of vibrations. You can get a couple of sqft for about $10-15 shipped. Just stick it in there and it should take care of it. A couple of sheets of second skin will do far more to get rid of rattles and vibration than any amount of polyfill will.
If you want to isolate the speakers you can use some foam placed and glued between them. I really don't think there is need for it with the way the soundbar is setup. But I'll find out this June when I start my install. It's going to be a pretty ridiculous install, nothing too crazy but I'm going to attempt to do a SQ build using the factory headunit and factory locations.
|04-08-2014 08:46 PM|
|mhicanders||It seems to me that the point of stuffing the sound bar is to isolate the left/right speakers.. depending on the music.. you can end up with one speaker essentially damping the other speaker when they are in the same air space. Try to stuff the space where the dome light is.. I believe some have dropped the dome light and stuffed that empty space with low expanding spray foam.|
|04-08-2014 08:28 PM|
So, after doing what you did and over stuffing it, I removed some stuffing and made sure that it wasn't crowding the speaker. I had realized when I pulled the speaker out that all the stuffing was actually on top of the speaker.
Don't be afraid to under stuff.
|04-08-2014 06:47 PM|
|04-08-2014 09:47 AM|
Polyfilled sound bar?
So I read a few threads about taking the speakers out of the sound bar and stuffing the hollow portion with Polyfil. It's supposed to be a little trick to get better sound quality so I figured hey, why not? However, nobody specified exactly how much to stuff in there.. I tried it yesterday and I can't really say I hear much of a difference. In fact, when I isolated the audio to the sound bar, it sounds kinda muffled. Perhaps I stuffed too much in there.(that's what she said) Has anyone else done this mod? If so can someone recommend a better technique for getting it to sound more crisp.
|04-05-2014 04:55 PM|
|Flashgordo||I put some poly fill in behind my sub and sound bar speakers today. Didn't notice any change when I sat in the drivers seat. Going to remove some poly from behind the speakers tomorrow like TexMedic suggested, and see how or if it changes anything.|
|04-04-2014 04:49 AM|
|tomgillotti||Thanks for the feedback. I'll mess with it more this weekend.|
|04-03-2014 11:33 PM|
Also, when stuffing polyfill people tend to go overboard and really pack it in there. It should be fairly loose and the fibers should still be able move a little bit. If it's too tight it basically just decreases the effective volume of the enclosure and you could be bottoming out your speakers.
Try taking some out then seeing how it sounds.
When you do polyfill you should add some, see how it sounds, add a little more and keep doing that until you get the sound you want. Think of it kind of like adding seasoning to your food.
|04-03-2014 05:55 PM|
So, I'm noticing a "boing-ey" type sound coming from the speakers after the poly-fill. It happens with higher base songs....
Did I over fill the sound bar? Sub seems to sound good, but rear speakers not so much. I put the fill all the way around the speakers...
|04-02-2014 08:56 PM|
The soundbar is going to just be rear fill so midrange back there should be good. You don't want highs stabbing you in the ear being that they are that close and you aren't going to get much bass in a speaker that will fit in there. However, most "stereo guys" will probably tell you that speakers in the soundbar are worthless because you want your sound stage up front so just spend the extra money to get a great set of components up front and a nice sub in the back.
That being said, what you put in depends on what you want.
I'm going to take some vacation time this summer and install all the gear I've been collecting and I got components for up front and a pair of 2 ways for the sound bar.
I'm going to be using the 3sixty.3 but even if you use the built in crossovers in an amp or the passive crossovers attached to the speakers you can make some adjustments to the sound coming out of the soundbar speakers.
I guess to sum it up, keep components with separate tweeters up front and a 2 way or just a midrange in the sound bar.
Edit: And just to add to the polyfill discussion, that's not something that is typically just a situation where you stuff in as much as you can. Deadening will work better for reducing rattle and improving sound.
|04-02-2014 08:33 PM|
Posted same thing in other thread...
Poly-filled the sound bar and sub. Not sure I notice a difference, but I think there is one. I just took the hard top off this past weekend, so that doesn't make it easier to tell.
Either way, $5.98 spent in two pillows... it didn't make it worse as far as I can tell.
|04-01-2014 08:10 PM|
Just thinking out loud (I'm not an audiophile either), but would it make more sense to go with a two way up front since there are already tweeters in the front and maybe even a two way in the sound bar for a deeper sound (I could see three way making more sense for the sound bar though)...?
Really, I'm out of my league with this stuff though...
|04-01-2014 03:46 PM|
|03-31-2014 08:31 PM|
Something simple folks... turn down your bass output on your head unit!
Turning it up too much to try & force it to sound good only makes things rattle and sound worse!
Turn down the bass, turn up the volume - sound quality improves and you loose the rattle!
|03-31-2014 08:24 PM|
|03-31-2014 06:59 PM|
|03-31-2014 06:41 PM|
|03-23-2014 03:51 PM|
YouTube how to link
|03-15-2014 07:38 PM|
Filled mine with road apples and cow pies, now my music really stinks.........
I really am sorry I couldn't help it
|03-15-2014 04:17 PM|
|bravens1||Done.....the bass buzzing off the plastic sound bar is now gone.....was it was worth cutting open an old pillow and 20 minutes of my time|
|03-15-2014 01:57 PM|
|03-15-2014 01:01 PM|
|Freedom JK||I stuffed my sound bar yesterday and it does sound better. I also stuffed the subwoofer enclosure and I noticed that the bass decreased a lot. I removed the poly fill from the subwoofer but I left it I'm the sound bar and it sounds great|
|03-15-2014 12:50 PM|
|Mike5087||X2 on the dome light rattle. I wrapped a Velcro strap around it. Helps a little but still is annoying.|
|03-15-2014 12:49 PM|
I'll check that, thanks. Rattle goes away if I hold the dome light. So I'm guessing it's the dome that's causing the noise
|03-15-2014 12:30 PM|
|Scott2373||Polyfill made my aftermarket speakers (Pioneers) come alive! What a huge difference! For those that say it did nothing, you really have to pack it tight!|
|03-15-2014 09:34 AM|
|This thread has more than 30 replies. Click here to review the whole thread.|