|02-01-2012 09:34 PM|
|02-01-2012 12:11 AM|
|Battlecat||Looks great! The ace bumpers/rails are on the top of my to do list.|
|01-31-2012 11:28 PM|
Not sure if the lifetime warentee transfers.
www.acejeep.com for more info
|01-31-2012 11:24 PM|
How was the winch and lights install?
|01-31-2012 11:22 PM|
Also, if you start in the upper right hand corner, facing the jeep / driver side, and then do bottom left hand corner, facing the jeep / passenger side, all the other bolts should fit in without any extra drilling. I found a pipe just smaller than the holes and a 5lb hammer helped moving it around as I tightened up the bolts. I would also suggest getting some grade 8 hardware for the nuts and bolts on the front bumper.
|01-31-2012 11:17 PM|
|01-31-2012 11:05 PM|
|jsmithtx||Jeep looks great. Can you give a little more info and pictures of the front bumper? Looking to do mods, I have a 2008 same color.|
|01-31-2012 10:22 PM|
What are some paying for a 2 door set of ACE sliders?
Found a set "like new" for $200
|01-31-2012 09:02 PM|
|themoneypit||i have the front stubby and rails and love em'. just waiting for a rear with a tire swing and i'll be set.|
|01-31-2012 04:52 PM|
would you mind posting something in this thread about your front bumper? This is an effort to make a consolidated list/review of front bumpers:
|01-31-2012 04:49 PM|
Very nice! I'm installing my Ace rails this weekend, can't wait!
Those bumpers look really nice too. Any chance you could post a couple more photos of the front maybe at a slight angle without the lights on?
|01-31-2012 12:09 PM|
|Bwgas||No mine does not the pump it's a 2007. I think the 2012 is the start of the pump being in the way|
|01-31-2012 11:47 AM|
|01-31-2012 11:23 AM|
So you didnt have to do any of this for your front bumper?
Here is what we typically do for the pump re-locate for our bumpers. Here are a few pics during the process. We remove the factory welded threaded studs and use new hardware to mount pump on the opposite side of the factory pump bracket. This lowers the pump about 2 inches giving enough room for bumper clearance.
Also trim the crash bar bracket in two spots. These brackets have changed over the years and are not always the same. Here is a pic below the tape we trim to keep a even height with the cross bar.
|01-31-2012 10:48 AM|
|Bwgas||No mods but I enlarge the bolt hole on driver side upper right and upper bolt hole left hand side. Passenger side made it real easy then. I had factory fog lights will fit in nice had to drill out the holes a little on the fog lights mounting brackets to use aces screws which work great.|
|01-31-2012 06:45 AM|
|rs87277||did u have to cut or do any mods for the front bumper?|
|01-30-2012 10:12 PM|
|01-30-2012 06:07 PM|
|01-30-2012 05:54 PM|
|01-30-2012 05:51 PM|
|Red Sahara||You made me jealous. Looks great.|
|01-30-2012 05:30 PM|
Ace bumpers and rock rails
I got them all on!!!!!I uploaded some pictures hope they turn out. Ace sure makes nice stuff. !!!!!