|02-05-2012 11:20 PM|
|Bluegrass||thanks Rex but got it worked out with moving the door hitches around.|
|02-04-2012 05:47 PM|
|JEEPASAURUSREX||redrill the striker ? if you loosen the torx on the end , the striker itself they are usually in a bigger hole and you can move the pin around once loose.|
|02-04-2012 05:26 PM|
|Bluegrass||HELL YEAH.. just got it 14 hours ahead of time before i lost the time frame. Thanks for all the help.. Only stripped three bolts along the way.|
|02-04-2012 04:27 AM|
|Bluegrass||thanks Fruitland.. that will save me a good bit of time and pain i'm sure..|
|02-03-2012 05:54 PM|
|Ibuildembig||you can, but most of the time the one on the tub needs adjusting|
|02-03-2012 05:53 PM|
ok.. i think i got it.. I need to loosen the plates on the door it self then put it on. Line it up .. Then tighten to fit.
Thanks for the help...
|02-03-2012 05:46 PM|
|Bluegrass||it is sitting about a half inch to high for the door to line up. I tried to move the door strike but i don't see a place for it to re drill it.|
|02-03-2012 05:38 PM|
|Ibuildembig||The bottom hinge that bolts to the tub right above where it says JEEP. Loosen those torx and you can move the hinge around.|
|02-03-2012 05:33 PM|
|Bluegrass||Can you explain a bit on that? I don't understand how to adjust them. I can't go without doors right now it's still pretty cold at night and to cold to take off the hard top and go with the low doors.|
|02-03-2012 04:45 PM|
|Ibuildembig||None of them fit exact, you can adjust the hinges on the front of the tub and the striker on the back.|
|02-03-2012 04:44 PM|
Yj Hard Door Problem HELP PLEASE !
I took the hard doors of a 89 to put onto a 87 buy they do not line up with the latches ! Anyone know why or how i can go about fixing ??