|05-04-2012 04:22 PM|
|05-04-2012 04:01 PM|
|rando||i have the same trac bar on my jeep. i am wanting a replacement tie rod for it does any body have a part number or description to get one at a parts store.|
|03-05-2008 05:52 PM|
|03-05-2008 12:08 PM|
|BPD119||Joe ehat one did you go with?|
|03-05-2008 01:52 AM|
|Joe Dirt||I got so sick of mine that I replaced it with a better one.|
|03-04-2008 07:29 PM|
I usually put a jack under rod ends if they like to move inside the taper. Just put a little pressure on the rod end to keep it from spinning the tighten it again.
If that doesn't work out well ditch it and buy a JKS.
|03-04-2008 06:24 PM|
Help with Track Bar
I have the Full traction track bar. it has a screw in tie rod end with the nut and cotter pin. recently i noticed the nut was loose and it has been making a clunk noise when i turn, and hit bumps.
i took out the cotter pin and attempted to tighten the nut down, but the whole stud and nut turn, after a while i was able to finally get it somewhat tight, but this doesnt seem normal, i am not impressed with this track bar, is there an alternative one to use or is just a bad tie rod end? Also if i do get a different bar is it going to make a difference that i had to drill out the hole on the axle end for the bolt to fit with the new full traction one?
any help would be great