Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > Communications and Electronics > crap new sub just quit

Join Wrangler Forum Today

Thread: crap new sub just quit Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-15-2012 06:45 PM
Johnboy11 My seat has that forward tumble deal. It will never fit lol
02-15-2012 10:17 AM
desertgoose The m500 will fit under the driver seat. When my amp dies on me I'm gonna pull the seat again and suspend it about an inch off the floor with metal brackets so it doesn't get flooded if I get stuck in the rain. Just a thought...
02-15-2012 02:27 AM
s3nt3nc3d I usually mount my amps to the box...or on my last build, I had a compartment built onto the box that was covered and my amp was mounted inside of it. Had plenty of airflow for cooling, but was covered on top to protect it from rainfall...aside from torrential rainfall that came in the sides.
02-15-2012 12:45 AM
Johnboy11 I think I am going have to put it in the cubby next to the sub. I have some tools there and a jack, but I guess I gotta give it up
02-14-2012 09:36 PM
desertgoose Can ya fit it on the back of the seat towards the bottom in front of the box?
02-14-2012 08:21 PM
Johnboy11 damn where to mount it then, kinda a big amp. I don't want rain to get on it either. i like my little trunks space also, hmmmmm
02-14-2012 08:18 PM
desertgoose You can mount on bare metal if you want, but I wouldn't put it there if its touching the seat. I used to have that amp runnimg 2 ohm and it would get toasty with 2" clearance above it.
02-14-2012 07:39 PM
Johnboy11 Ok I checked all the wiring, got a brand new Solo Baric dual 4ohm sub set to parralel, reset the head unit to factory (in case some random setting was bad. got all this done to find out my Alpine m-500 amp was bad . It was fricken brand new. So traded it in for a brand new one. It's weird the blue light was on but it was not working right. Works great now!!!!, now one last question. I want to mount the amp under the rear seat, but I have no carpet. Is it ok to mount it o the bare metal floor and will the seat be to low for good air flow?. I just like it under there for security. My seat is a B>tch to lift up now with that box in there. SO no stealing it under there.
02-14-2012 02:53 PM
desertgoose Maybe a wire came off the sub or the terminal in the box. I had a sub quit on me when a wire frayed and grounded out on the sub basket.
02-14-2012 01:25 PM
AZDEZJEEPER Depending on the amp, either a light would be flashing, or a different color light would come on.
02-14-2012 01:40 AM
s3nt3nc3d I thought in your other thread you said you exchanged it for a dual 4 ohm sub? Wired in series, that would be 8 ohms (2 ohms in parallel)...

If the ground connection were bad, wouldn't the light be off on the amp?
02-13-2012 11:59 PM
AZDEZJEEPER Most likely just a bad ground connection. Did you check the RCA pick ups going into your head unit and amp?
02-13-2012 11:32 PM
Jma20a Where is the amp grounded? It needs to be grounded metal to metal. So you may need to do some sanding at your ground location
02-13-2012 11:22 PM
Johnboy11 I had it set up as a series so it was just running 4 ohm.
02-13-2012 11:17 PM
Jma20a That amp is not rated at 2 ohm minimum. You need a 4 ohm duel voice coil sub
02-13-2012 10:09 PM
Johnboy11 How exactly do I do that, also it's a dual voice coil 2ohm
02-13-2012 09:21 PM
I-Want-A-Jeep Check the impedance of the sub using a multimeter...
02-13-2012 08:47 PM
crap new sub just quit

I just put in the new kicker sub with a alpine m-500 amp and was driving along today and the sub just quit. I checked all the wires, the fuses were good the light on the amp is on, nothing!! It was playing fine then just quit. WTFturned it off for a hour and still no sub, speakers work great ect... HELP!!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:18 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC