|02-22-2012 03:24 PM|
When I installed my electric fan and whenever the controller got a little wet it would fail. I bought a hobby box from radio shack finally got around to installing the three way switch that turns it off-on-auto. The hobby box was the perfect size for the advanceauto fan controller, two relays and fuse holder. Just did it yesterday. Still need to wrap the wires.
|02-22-2012 01:35 PM|
|Peepers||I used a tupperware box for my fuses and all my relays are screwed into the back of the engine compartment.|
|02-22-2012 01:27 PM|
I got just the thing for your relays. You can get 5 relays and all relays and the relay coils are fuse protected. It comes fully wired with different color wire leads. It's also more water proof than the stock fuse box. Best part is they are only $105 with relays and fuses included shipped and comes in 3 different wiring configurations. Your over have that cost if you just went out and bought the standard relays and harness and fuses and holders. WagonGear sells them, at the bottom of the page "Universal Auxiliary Relay Box". Here is a thread post with a detailed description of them and the configurations are on post #11.
There is also another way. Check in your stock fuse box. You most likely have a few empty relay spots and fuse spots. Not sure if other year TJ's have it but my 03 non-Rubicon still has an empty slot for the extra relays for the lockers. I picked up an extra relay block from the junk yard that will fit in the empty slot that takes 4 of the narrow relays. I'm going to use that to run my off-road lights, rock lights, compressor, and whatever else I might add. Won't be easy but will look stock and I don't have to find any extra room.
|02-22-2012 10:30 AM|
|02-21-2012 05:10 PM|
Who makes a relay panel/box/etc.?
looking for something to house my relays for my lights. not going to spend 300+ on an sPod...and i dont want them all over the place in the engine bay as they are presently...ive searched all over! helppp