|10-03-2012 09:17 PM|
OP, those fenders look awesome
BTW...What front bumper is that? I love it!!
|10-03-2012 09:16 PM|
|10-02-2012 11:16 AM|
|Kssig1||I agree your fenders look great!|
|10-02-2012 11:05 AM|
The battery sensor is there for a reason. It monitors the battery temperature.
If the battery gets too hot, the sensor triggers the PCM into shutting down the alternator till the battery cools.
Ask me about what happens when a battery goes ballistic, when you are running down the road at night on a curve. 6 months eating through a straw, and 2 years learning how to walk again is not fun.
|10-01-2012 10:49 PM|
|03-04-2012 05:17 PM|
I finally finished. Today I installed the final piece to the puzzle. I installed the
|03-03-2012 11:55 AM|
|Casotakar1229||think those fenders look awesome!|
|03-03-2012 10:40 AM|
|Serge627||Looks great! Love the way the fenders look with your set up.|
|03-02-2012 08:29 PM|
|Evian||Some people have had problems reinstalling their windshield wiper fluid reservoir. This is what you have to do to it for it to fit properly. You will have to relocated the two rear pumps on your tank. I placed my pumps on the side of the tank. I tried installing it without moving them but the tank was too high and it didn't allow my hood to close.|
|02-29-2012 03:53 PM|
|Aunt Flow||Thing looks good!!!!|
|02-29-2012 03:09 PM|
|Evian||Here is a photo of how to relocate the factory air cleaner. You don't have to replace the factory air cleaner (if you don' t have airconditioning in your Jeep). All you have to do is relocate it to the edge of the fender. I bolted mine there.|
|02-24-2012 12:40 AM|
I heard the same thing but I don't buy that story. I don't see why it would need it. The alternator should pump out the same voltage no matter what happens.
|02-24-2012 12:38 AM|
That mega phone is my alarm siren. It is called the white siren. It is extremely loud . I can hear it clearly a block away .
|02-23-2012 11:08 PM|
|02-23-2012 10:48 PM|
|wvhillbilly||Is that a mega phone under your hood lol|
|02-23-2012 06:39 PM|
True so true! Unlike most owners of these fenders I will be using mine in the real jungle.
As to relocating what was original underneath the hood, no problems arouse. It was very easy to figure out. Like I mentioned previously the hardest part was removing the original equipment and those damn Torx Bolts.
|02-23-2012 12:46 PM|
You'll be even happier with them when you actually put them to use. These fenders stand up to some pretty hardcore damage.
How'd all the underhood relocation go?
|02-22-2012 11:25 PM|
|Evian||Today I picked up the small bullet style turnsignal for the front fenders. Can't wait for them to roll in. I am stilling running around with my original battery. I haven't opted for an Optima battery yet. My snorkel is currently removed. That will have to wait a few more days before I get around to reinstalling it. I am not sure to reuse the Rock River Snorkel or swap it out for another snorkel I have lying around the garage. T&T Custom doesn't lie about how easy it is to install. Installing them took only minutes. The toughest part is removing the original fender. I broke about 4 bolts|
|02-20-2012 11:47 PM|
Finally installed my T&T fenders and corner armor what a nightmare!
The TNT parts were perfect. I couldn't be happier with T&T Custom . The nightmare was removing the torx bolts and drilling out all the bolts I broke . I found things in my Jeep that I didn't know existed. Can anyone tell me why there is a switch underneath the battery? It is attached to the battery tray. Did all Wranglers come with two battery trays? Mine apparently did .