|02-27-2012 01:54 PM|
Like SnailPower said
Checkout inside the right rear taillight opening in the fender. I'd say there's 3-4 cu feet in there, and it's pretty well sealed and easy access for wires. I don't know how easy it is to get the compressor in the taillight hole. No way a tank would fit there but I've seen others put a tank in the jack/jumper cable/ tow chain compartment.
|02-27-2012 01:01 PM|
|Snailpower||I saw a thread on another JK or Wrangler website on putting it behind the passenger tail light, inside the quarter panel. It was months ago I was looking at it. I think building a cover for it and mounting under the Jeep may not be a bad idea, as long as it is protected.|
|02-27-2012 11:55 AM|
There goes my dual battery install. Guess I'll just keep a spare when I go out in the wilderness
|02-27-2012 11:09 AM|
I still haven't gotten mine but I have been looking into doing this also. Its going to be really tough, The new engine bay doesn't have a lot of room...
I did find this great post that had an install on an older Jeep
DIY: On Board Air (Engine Bay Mounted) - JKowners.com : Jeep Wrangler JK Forum
|02-26-2012 10:33 PM|
|New2012JEEP||Replace your stock muffler and stick it under there, ha. There is so much room down there, not sure what to do with it yet.|
|02-26-2012 09:13 PM|
Ok, not entirely the answer you were looking for... But...
Mine fits perfectly under the center/back seat in it's little bag! Just don't try putting the seats down with it under there. The little plastic air filter could be crunched pretty easily.
|02-26-2012 08:50 PM|
|dabolt55||mines on order, I will wait on feed back.|
|02-26-2012 08:46 PM|
I don't think mounting near or on top of the battery is a good idea. There was a link with Sneck's "sale" thread that said the MV can get up to 200║+ with prolonged airing duties.
I know the engine itself gets hot, but...
I could be totally wrong.
|02-26-2012 08:43 PM|
Where to mount portable compressor in 2012 JKUR
So I just received the Q Industries Superflow MV50 12V portable air compressor I ordered from the Amazon one day sale last Friday. I would like to mount it somewhere under the hood and eventually connect it to a 2 gal tank with remote connections in the front and back of the vehicle. Right now I would like to just find a home for it to use it if needed before I get the whole project completed. There is so little space available under the hood but I found that if I place it over the battery it seems to barely fit. So does anyone think this is a bad idea? Any problems with mounting it there? I have attached a pic of it laying on the battery. I think I will have to fab up some sort of mount to keep it off the battery and make it easily removable if I need to get more battery access. And if anyone has mounted a similar portable compressor under the hood, how and where did you do it? The MV50 is a bit large BTW. Thanks!