|02-27-2012 06:33 PM|
Getting the factory finish off the cover is a PITA, ask me how I know.
Started out trying to sand blast and except where there was corrosion it just bounced off. Wound up using a stiff wire wheel on an angle grinder.
Why can't they make the paint on the outside stand up like that !
|02-26-2012 10:42 PM|
|Wheel2Work||Make sure that the mating surfaces are clean before putting anything back together too! Then the trick is to tighten in stages following the recommended torque sequence... finger tighten the bolts, then run them to 1/2 of the final torque value. Final pass should be at full torque and you should have no leaks, providing the valve cover isn't "tweaked" from a previous repair.|
|02-26-2012 12:25 PM|
|Hammerdown||Yeah, they got gorgeous ones in cast aluminum but they are all for the 6. How hard its it to take it off and and put it back on? I know there are probably a few screws but there are always the unexpected, especially sealing it.|
|02-26-2012 01:39 AM|
|02-26-2012 12:26 AM|
|02-26-2012 12:05 AM|
|UnlimitedLJ04||you can always take your valve cover off, tape the openings, and paint it whatever color you want.|
|02-25-2012 11:15 PM|
Search Results - Quadratec
scroll down youll see some
|02-25-2012 10:43 PM|
Do they make stylish valve covers?
One of the first things you notice in an engine is the valve cover. Who makes some good looking ones(for the I4)?