|03-19-2008 07:58 AM|
|03-19-2008 06:16 AM|
|03-18-2008 11:39 PM|
|03-18-2008 08:34 PM|
|richp||What brand filter is on there ? If it's a fram change it to a Mobil-1, K&N, purolator, hastings, NAPA gold, anything but a fram or a fram rebadged.|
|03-18-2008 07:16 PM|
|03-18-2008 06:47 PM|
|4point||You just had to drag bob into this................didn't you.|
|03-18-2008 06:43 PM|
Did it look like this?
And did it have a 2-wire lead attached to it?
If yes, then that was it.
Oil Pressure Sending Unit, Oil Pressure Switch, Oil Sending Unit, Oil Pressure deely-bob
|03-18-2008 06:09 PM|
Alright, I needed a 1 1/16' deep socket to remove it, pressure sender, that is. The reason I am questioning weather I replaced the right thing or not is:
1. because of the placement of it. behind filter vs. above filter
2. because others reffered to the part as being removed with a torx head screw driver, two screws.
|03-18-2008 06:04 PM|
|AzTJ||Call it what you want, but I think you are referring to the same thing. Sending unit or pressure sender...|
|03-18-2008 06:03 PM|
So, are there problems with both the oil pressure sending unit, which I replaced, behind the filter, AND the oil pressure sender? above the filter?
Thanks for the replys.
|03-18-2008 06:00 PM|
|parrot head||Since it is a sport I assume it is a 4.0?|
|03-18-2008 05:58 PM|
|parrot head||The oil pressure sender is just on top of the oil filter housing and points toward the firewall. You can see it easily if you look at the oil filter from above. It doesn't thread directly into the block, it threads into the oil filter housing.|
|03-18-2008 05:06 PM|
Oil pressure sender, replaced, I think....
This may sound like a stupid question, but I was searching the forums for a solution to my fiance's 2000 Wrangler Sport problem. Little to no oil pressure at idle when warm. I replaced, or so I think, the oil pressure sending unit. I read something that is making me thing I replaced the wrong sensor. Which one specifically is the oil pressure sending unit?
The thing I replaced was some sort of a sensor BEHIND the oil filter, more towards the firewall, that threaded directly into the block. Is this the pressure sending unit? I have heard others refer to it as being above the oil filter, which this definitly was not. Sorry for the long post, but I hope I replaced the wrong thing and this is will be easier than I thought. Any help is appreciated. A picture might help also if anyone has one.