|02-29-2012 05:55 PM|
|eScott||I painted the gauge surround and center panel with bed liner, and it's holding up great. I also went from faded gray to black using dupli color without any issues so far.|
|02-29-2012 01:55 PM|
|02-29-2012 01:34 PM|
Im thinking about doing a lot of the faded interior parts in bedliner spray as well. Wonder if you would need to use the adhesion promoter as well. Or, if that bedliner spray will stick to the plastic and be durable over time......
|02-29-2012 09:36 AM|
|Dragonii||Airbags should still work just fine. In mine I'm not even painting it where the air bags are located, just the glove box cover, speaker grill and middle section of the door panel. But the air bag would still work if you painted over it.|
|02-29-2012 08:39 AM|
|Grateful Parrot||I know this is a stupid question, but I'll throw it out there. I was thinking about painting mine with bedliner. Are you worried that the air bags won't function properly? My TJ is still a DD with daughter most of the time.|
|02-29-2012 08:35 AM|
|Dragonii||I think I may sand down the Fusion a bit and try to go over it with the Flame Red color match.|
|02-29-2012 08:05 AM|
|Jollyczar||I have a buddy who works at a Body/paint shop at a local Ford lot. He hooked me up with a good quality adhesion promoter for plastic surfaces. I painted mine up a few years ago and they have been holding up well. I went from faded gray to black. These pics are old (I've since finished the entire interior including the doors). Just prep it right and you should be fine. And to answer your last question, I pulled everything out first.|
|02-28-2012 11:30 PM|
So I tried painting some of the interior of my Jeep red using Fusion... unfortunately the reds don't match very well.
I know that Duplicolor makes a color match paint that is pretty close to the Flame red, but how well would it work on plastic? Could I pull it off if a prime first?