|03-07-2012 03:36 PM|
When I get all done, on one side of my jeep it will have sticker that says
And on the other side it will say
|03-07-2012 08:44 AM|
The activation only requires a 12vdc power source to engage the coil. There is also a sensor that sends a signal back to the PCM to inform of "if" and "when" the locker actually engages. This controls the little diff lock light on the dash.
It is not needed but so you will more than likely just hook up the connection on top of the differential housing to a toggle switch and leave the threaded looking connector disconnected. It is located just above centerline and on the backside of the left side of the differential housing.
|03-05-2012 08:10 PM|
|JEEPDON||OK thanks a bunch|
|03-05-2012 05:58 AM|
|Imped||It's not ECM-controlled. Just need a 12V power switch and as long as it comes with the pigtail, you're good. At least that's how things went with the last JK axle swap I took part in.|
|03-05-2012 04:33 AM|
Question for tech guru's
I have found where I can get a Dana 44 complete front from a Rubicon JK.
My Question is, does thje e-locker just require 12vdc to activate?
I.E. can I just run a wire to it, VIA a toggle switch on the dash, from any 12VDC power source, to lock it in?? Or is it some electronic gizmo that HAS to go through the ECM??
Thanks in advance