|03-11-2012 04:33 PM|
|konajeep||Thanks it was the wiring plug under the dash. Corrosion|
|03-09-2012 12:51 AM|
You could also check/clean the connections in the wiring harness leading to the tail lights in each corner (looking up into each back corner from the underside). Disconnect, clean, add dielectric grease.
Because the center tail light works, I would doubt the break switch is the issue.
|03-08-2012 08:57 PM|
The Tail Lights are ground through the housing to the body. There are 3 bolts that hold your tail lights on. Those are the grounding bolts as well.
Maybe your brake switch is bad, its connected to the brake pedal. Play with it and see if you get any flickers.
|03-08-2012 07:31 PM|
Why do i have the middle light working? Any ideas where to look for bad ground
|03-08-2012 06:28 PM|
|Garyk||You've probably got a loose or bad ground. If the light worked before you had it apart, then I would look at connections etc for corrosion...|
|03-08-2012 06:26 PM|
1 out of 3 brake lights
95 YJ I had all 3 brake lights working,[tail lights work] then drivers side went out. I checked and cleaned bulb and socket put it back and both sides quit. The only brake light working is the one over the spare tire. Tail lights still work. Any ideas?