|09-24-2011 12:10 PM|
|sk8er||I sort of have the same problem with my 95, all my lights work except when i hit the brakes. the third light works but the brake lights do nothing. i have driving lights, blinkers, and hazzards but no brake lights. i have checked the fuse and replaced the fuse under the driver side. anyone have any ideas. I need to get my baby inspected.|
|03-28-2008 08:07 PM|
|autogyver||when they started using third brake lights is when the 4ways were not overrun by the brake lights, the third brake light lights up while the 2 lower lights still flash. I do state inspections in N.C. and there was even a bulletin that explained this, tell the inspector to look back at his requirements.... good luck|
|03-28-2008 07:22 PM|
|Smeghead||I'm a loser.|
|03-28-2008 05:57 PM|
|03-28-2008 12:46 AM|
|JeepCommandoja||recently i noticed that my break lights are not working but my tail lights are still functioning; i check the fuse and the lights but both are fine; i was looking at the connection to the break pedal but it seems to be ok; anyone had this problem?|
|03-27-2008 11:42 PM|
|Smeghead||You shouldnt need brake lights when the hazard lights are on because you shouldnt drive with the hazards on, tell him that then kick him in the nuts!|
|03-27-2008 11:23 PM|
|jbone03||I'm actually from CT but I'm currently living in germany. When I was registering for WF It asked for my location but only included the U.S. Guess they didn't know there are Jeep owners worldwide.|
|03-27-2008 05:08 PM|
Which DMV branch did you go to? Sometimes the inspectors don't know there a$$ from a hole in the ground, especially at the branch offices. I have always had better luck going to the main DMV office in Wethersfield.
|03-27-2008 02:05 PM|
|jbone03||Thanks for the quick reply. Maybe the inspertor was mistaken.|
|03-27-2008 01:52 PM|
|03-27-2008 01:30 PM|
Brake Light Problems?
Hi, New here and a proud new owner of a 99 Wrangler Sport. Just went through Vehicle inspection and was told the break lights dont work and 4 way flashers dont work. Any way I took apart and cleaned the contacts in the turn signal/ hazard switch which fixed the 4 way problem. Now the break lights seem to work fine. The only thing I can think of is the break lights don't cancle out the 4 way flashers when the breaks are applied. Are they supposed to? Also the high mount works fine either way. Am I missing something? Please help.