|03-13-2012 11:42 AM|
|Hammerdown||Ah, set screw. It is brilliant, Sparky! Thank you.|
|03-13-2012 10:03 AM|
Since you still have some stud sticking up, you could try this route.
Product Results: ck-rm20 | Pep Boys
It is supposted to attach with set screws coming in from the side of the base.
|03-12-2012 11:22 PM|
|s14sh3r||I think there are a couple people parting out TJs in the for sale section.|
|03-12-2012 11:01 PM|
|03-12-2012 10:58 PM|
|Hammerdown||I can cut the screw with my Dremel tool but I have to first make sure I can get the base. Looking for it in a junk yard is not a real option. This is what I have done in the meantime. Wrapped a few layers of teflon tape and screwed the antenna over it. It is holding for now and the radio works.|
|03-12-2012 10:54 PM|
Have you ever used an ohmmeter to see how conductive JB-Weld, an epoxy, is? Try it and you'll see it's not a conductor. JB-Weld has iron filings in it but because it is an epoxy, JB-Weld is not conductive. You don't want to use JB-Weld between pieces that have to be electrically connected with each other.
JB-Weld confirms their product is actually an insulator at http://jbweld.net/faq.php where they say:
"Q: Will J-B Weld conduct electricity?
A: No. J-B Weld is not considered to be a conductor. It is an insulator. "
|03-12-2012 10:52 PM|
|the great moo||You can use JB weld but you will sacrifice signal strength. JB weld is conducted but not at the same rate as the rest of the metal. On a CB you want as a little interference as possible.|
|03-12-2012 10:44 PM|
When I bought a new antenna base from a junkyard Jeep, I also bought its matching antenna since I didn't have one.
|03-11-2012 07:49 PM|
|03-11-2012 07:46 PM|
|Hammerdown||Sherpa, I tried to pop it off but as you can see the screw is in the way. How do you get around that without cutting it?|
|03-11-2012 06:51 PM|
|Sherpa||I would just replace the antenna base. It is outrageously easy to do. The 'cap' pops off, revealing three screws. Remove those screws and the base lifts away from the body. Now grab a good base off a junkyard TJ and put it on your Jeep, then screw your antenna onto the base. Problem solved.|
|03-11-2012 06:32 PM|
Maybe....but Id get a new set up
back in my rc car days with stripped bolt holes in alumnuim engine blocks we use to put pieces if steel wool from a brillo pad in the thread holes,screw in the bolts and the threads would hold for awhile
could you possibly drill a hole and put a cotter pin holding the antenna on?
try the jb weld,most people swear by the stuff.I think its a gimmick and only serves well on certain things.....not everything
loctite makes some stronger metal like two part epoxies
|03-11-2012 05:23 PM|
Can I JB weld radio antenna to the base?
To make a long a story short, I have stripped the nipple on the antenna base attached to the body. Bought a universal whip and it would fit if the threads were OK. So my question is would JB weld work? Is it electrically conductive or may be there is still enough metal to metal contact to work? If I knew for sure the nipple would screw out I would force it but it doesn't budge.