Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Electrical or WTF?!

Join Wrangler Forum Today


Thread: Electrical or WTF?! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-14-2012 08:17 AM
bc3_Jeep X2 on the ground issue...... grounds that are loose or missing can cause all kinds of "gremlins"

As far as the "no start"...... I would also suspect distributor at 180 off....... suggest going back to basics..... setting #1 cylinder at TDC and checking to see if distributor is pointing to correct wire. This assume that timing is correct......
03-14-2012 06:47 AM
jefferyfghezzi I would suspect you connected some of the wires incorrectly,missed a ground somewhere and you could be back feeding somewhere or pulling the ground from another grounding path. Try grounding the (-)battery post to the engne block with a jumper cable and another to the frame.
03-14-2012 06:29 AM
Kevbz I think your gremlin guages are just that, gremlins that have to be worked out. A ecm doesn't control any of that.

Is there a chance the distributor is 180 degrees off?
03-14-2012 02:47 AM
Mattwahl28
Electrical or WTF?!

99 jeep wrangler sport
Automatic trans
Overhauled 6cyl stock 4.0

Just overhauled the engine in my 99 wrangler. Did everything by the book.
When i reinstalled the engine I had all connections and hoses labeled and was able to put everything back like it was.

I set the timing sprockets by the book and put everything back in using pics and notes as well as labels.

Won't start. It turns over and sounds like it wants to start for a moment but no luck.
Won't turn over in park has to be in neutral.
When I try to turn on lights they don't come on but the wipers do.
When I push the horn the bright lights indicator and hazard comes on on dash.

The dash gauges seem to be normal until I mess with turn signal ,lights , horn or wipers.

Note, new gas , plugs , wires , have spark in plugs, used same distributor but *new cap. *Had valves worked by professional and bearings as well as piston rings. I put it all back together and torqued head and all parts using itorkit.com specs.

Could this be as simple as a new ECM or a series of problems?

Any insight at all is highly appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:17 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC