Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Question on my TJ

Join Wrangler Forum Today


Thread: Question on my TJ Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-18-2012 11:37 AM
Kevbz
Quote:
Originally Posted by wiseguy52 View Post
Ok, so I have a 98 TJ with 65000 miles on it. I was having cooling issues with it and to make it short, I put a radiator, thermostat, and head gasket on it. The latest word is that the block or head is cracked. Coolant is getting into the oil now. So the garage I took it to said they could put an engine in it for $2500, another shop said not to bother and buy a new one. I have several questions that I hope the forum can help me with.

1. How much would a good condition 98 TJ hardtop, automatic, with a bad engine be worth to sell for parts? approximately?

2. Would it be worth the $2500 for a 2.5L engine or spend approximately $5k to have a Vortec V6 put into it?

3. Cut my losses, part it out and buy a newer Wrangler?

Thanks for any advice given.
Heres my opinion, or take on it if I were in your shoes.

1. worth a lot, kinda. Part out is a big time consuming endeavor. I am assuming its a 2.5L, auto tranny, NP231 transfercase, D35c rear end and D30 front, with 4.10 gears. (i am not positive on the auto drivelines configuration) but not an issue because after the initial rush of requests for parts, big and small, with multiple shipping quotes (that never pan out or low ball offers) you will be left with a lot stuff that will trickle out the door. If you have the room to store it, and take parts off as needed until they are mostly gone, you can make a lot of money. But you will not get it all back at once, meaning you will have to buy something with different cash, and let the old one pay you back slowly. I'd say a complete driver with bad engine would make you 2500-3500 over time parted. there are some folks that will buy it with a bad engine for the 2000-3000 range depending on the condition if they want a project jeep.

It all depends on how much time you have to invest in it, but on ebay, on forums, etc require shipping, and boxes, and tape and trips to the post office...it all adds up. Some days you may be boxing up a 5 dollar part, with 3 dollars worth of packaging material, and a two dollar trip to the post office

2. I know i can search right now and find a 2.5L complete, running for 500 or less (most are from v8 swaps). If you trust the source you can put it in with out opening it up, you've got >500 in the engine, and labor at 90ish an hour might be 900 more. If you have the money you can have a shop go over it for a extra $$ amount (check compression, main seals, pull the top end off and look at the valves, lifters, gaskets, etc) doing that and having it installed puts you in the 1500 range, or less. A I4 swap is ideal for the cost effective route, computers, mounts, tranny bell housing, accessories, are all the same.)

A lot plays into your personal situation, do you have enough cash to get it done, how soon do you need it running, can you part it out slowly or do you not have the room. can you sell it outright and put the cash plus some for another. Are shop rates high around you, are they low?

It a big decision, because once you pick a path, your following it to the end.

Personally I would find a 2.5L, have it looked over and have someone swap it in, and drive it. Parting leave a huge mess, occupy's alot of your time, and once you've sold of some parts, hard to reverse. And non factory swaps are ideal, but require the financial moneys to get it done. For 5000.00 for vortec V6, or even a I6, or V8, or even V10 for that matter...is still 5000.00. You can find complete TJ's for that price.

It's my opinion on it.

I guess you can ask yourself this. If i pm'ed you right now and said shipping cost is no object, and I want the seats and complete dash, can you physically remove them in a timely fashion, get them on a pallet and shipped (i'm paying premium) and then look at your jeep and think "only another year of this"
03-18-2012 10:52 AM
jrussblues On a 98 you can prob get a 350 swapped in if you shop around and do most of the work yourself for 2500.
03-18-2012 10:31 AM
KrzyMoke There is not a lot of info on your jeep in questions or pics but since I am a die hard Rubicon guy, I say you have 2 options.

if it is pretty beat, Part it and buy a Rubi OR

if it is in good shape, buy a "Stroker" and slap it in
03-18-2012 09:30 AM
trainsktg I was talking about spending money, not gas mileage.

Keith
03-18-2012 09:18 AM
lensam Economics dont come into play with Jeeps. The fours get the same mileage as the sixes
03-18-2012 09:13 AM
trainsktg Regarding point 2, the new I4 is your most economical option. If you are otherwise happy with your Jeep that's the route I'd go.

Regarding point 3, your are probably going to have to spend more that $2.5k or even $5k for a new Jeep that doesn't come with its own set of uncertainties, so a new Jeep is probably your most expensive option.

If you are financially able, this is probably a really good time to explore upgraded engines like the V6 you mentioned (not sure how feasible that is, but it sounds interesting) or a stroker.

Keith
03-17-2012 09:02 PM
wiseguy52
Question on my TJ

Ok, so I have a 98 TJ with 65000 miles on it. I was having cooling issues with it and to make it short, I put a radiator, thermostat, and head gasket on it. The latest word is that the block or head is cracked. Coolant is getting into the oil now. So the garage I took it to said they could put an engine in it for $2500, another shop said not to bother and buy a new one. I have several questions that I hope the forum can help me with.

1. How much would a good condition 98 TJ hardtop, automatic, with a bad engine be worth to sell for parts? approximately?

2. Would it be worth the $2500 for a 2.5L engine or spend approximately $5k to have a Vortec V6 put into it?

3. Cut my losses, part it out and buy a newer Wrangler?

Thanks for any advice given.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:02 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC