Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > should i do all my bearings in my d35

Join Wrangler Forum Today

Thread: should i do all my bearings in my d35 Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-02-2012 06:30 PM
Nas.a7x Know of any good threads or how 2 site I can't seem to find any
04-02-2012 07:11 AM
Nas.a7x Ya but finding one around here with the 4.10 gears won't b easy I've been looking for a while..
04-01-2012 11:03 PM
DirtyRob YOu could probably buy another whole rear in running condition fro lees than you will spend doing everything else, and it will take less time to change it
04-01-2012 08:48 PM
Nas.a7x Ya I'm talking about the rear. This will only be the second rear end I've done. I started to do the bushings today and had to cut almost all of the bolts and its a major pain I will have to finish that tomaro then I can start on the bearings (still nervous about doing it)
04-01-2012 01:36 PM
0III0forlife If it were me, i would definately replace all the bearings. the pinion bearing is most likely bad from a high angle on the driveshaft, so you could replace it and all might be fine, but if its bad from high miles, then all the other bearings have the same on them as well. As far as crushing the sleeve, have you ever heard of manual tools? like a breaker bar, air tools are nice if you have them, but my dad rebuilt any and all parts of jeeps back in the 1950's and he never used an air tool ever. Try it, you might like it if you slip and smash your knuckles a few JK. But, it is possible to do without air tools. Oh and by the way, the D35 is the rear axle, the front is a D30 if they are stock.
04-01-2012 11:35 AM
should i do all my bearings in my d35

Ok so I was going to replace my seals and front pinion bearing and axle seals and bearings but when I took my drive shaft out I could move my pinion up and down just a little should I replace all my bearings or jus the outer pinion bearing I don't want to have to do it twice. I do have access to guages to reset the back lash but not a good enough impact gun or compressor to crush the crush sleave

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:38 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC