Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > 2.5 to a 4.0 ??

Join Wrangler Forum Today


Thread: 2.5 to a 4.0 ?? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-13-2012 06:42 AM
brentd711 Mounts are different so you'll have to weld in replacements.
04-13-2012 02:40 AM
Pukeolicious If I can find a good deal on a 4.0 with a manual transmission, will they bolt right in or am I looking at relocating mounts?
04-12-2012 10:32 PM
Rebel_Ryders_Offroad These are the factory standards for the YJ:
2.5L manual - 4.10
2.5L auto - 3.73
4.0L manual - 3.55
4.0L auto - 3.07

Xjs
3.07 - used with 4.0L engine / manual transmission
3.31 - only available on older (pre87?) 2 door XJs with "Fuel Economy" package
3.55 - used with 4.0L engine / automatic transmission
3.73 - found in some XJs with the towing package
4.10 - used with 2.5L engine usually, and older XJs with the "Off-Highway Vehicle" package.
04-12-2012 09:39 PM
busemans auto trans 6 cylinders are 3.07 gears. cherokee with 4.0 and auto are usually 3.55-3.73 gears.
04-12-2012 09:34 PM
Timberwolf start looking for one with a 6 cylinder, you would need one as a donor anyway
04-12-2012 05:24 PM
Pukeolicious It is stock. I can hold 75, with my foot nearly buried. Any hills and the speed slips. Keep in mind that this is in Colorado with thin air. I burned 3/4's of a tank of gas between Denver and Colorado Springs trying to maintain 75-80 when returning from DIA.

It does fine in town, but I-25's speeds are a struggle.
04-12-2012 12:52 PM
Xpress You can't hold 75 on your 2.5? What size tires? What gearing? When was the last tuneup?

Mine holds 70 no problems, if I push it a bit more I'll roll 75 easily, on 29" tires. It did fine with 31's as well on stock gears.
04-12-2012 07:51 AM
brentd711 Yes, Yes and Yes.
04-12-2012 07:47 AM
Pukeolicious Not really reviving a dead thread since it is only a week old but I need some clarification on this.

I have a '93 with a 2.5 and a manual transmission. After driving it for the first time a few weeks ago I was really disappointed on the highway. I need an engine that can handle driving at 75 as well as offroad. The 2.5 cannot. You guys are saying the same year Wrangler with a 4.0 is a different beast? I was hoping I could simply drop in a 4.0 but you are saying I would have to replace the transmission and rework the gears as well?

If it requires that much work would I just be better off selling it and buying one with a 4.0?
04-04-2012 12:05 PM
Zombiekiller yeah if mine dies i may get a 350... but the 4cyls run forever so good luck with that... but it would be easier to sell your jeep and just buy one with a 6cyl
04-04-2012 10:25 AM
Xpress Depends on what gears are in the XJ axles. 3.55 and lower won't swap into a 4.10 carrier.

^^That's going to be hard, especially since the 4 cylinders will run forever.
04-04-2012 10:20 AM
YJ325i I had been wondering about the rear diff. I am running 31's atm, could I swap the gears from the doner XJ? I know this is a lot of work, but sometimes the process is half the fun.
04-04-2012 10:20 AM
Rockintheislander Drive it till the 4 banger gives up then drop in a 350/350 combo and go wild.
04-03-2012 11:40 PM
Xpress Depends on a few things:

What year is your 2.5L? 1987-1990 you have to swap the whole harness, 1991-1995 you can use the existing harness, just have to wire up the new injectors.

Would you rather swap in an engine or buy a Jeep with the 4.0 already in place?

Even so, you have to get bigger tires for the 4.10 gears. Manuals are 3.07 and autos are 3.55 I believe, for the 4.0, whereas the 4 cyl got 4.10's. Otherwise you'll be over-revving your 6 cyl. You are obviously going to need to swap in the AX15 and matching NP231J. And the computer, as well as weld on new mounts and whatnot.
04-03-2012 10:06 PM
YJ325i I was thinking of doing same thing, I am a mechanic so thought I had some advantages. All I hear from peeps is its not worth it, go buy a YJ w/ the 4.0L. Thought I would buy a cherokee doner that way I have anything I would need. brackets, harness's, exhaust parts, etc XJ's are cheap in my area and very populated at the junkyards. wranglers not so much
04-02-2012 11:55 AM
4Jeepn new trans, mod the t-case, weld in new motor mounts, new computer, new new new new new...Lots of stuff..
04-02-2012 11:48 AM
Red94wrangler
2.5 to a 4.0 ??

What all do you have to swap out need help or tips ?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:07 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC