|04-09-2012 11:22 AM|
|Bama-Jeeper||Aweseome, well I preciate all the input that was given!|
|04-05-2012 03:11 PM|
|Lbailey21||I was quoted around $650 front and rear for installation|
|04-05-2012 02:46 PM|
If you jack up your rearend off the ground...
spin one wheel... if the other goes the same direction, you have Limited slip and this is easy....
1. Mark the inside of the tire at the 6 oclock position.
2. mark your rear drive shaft at the 6 oclock position.
3. Rotate your tire one full revolution and count the number of times the drive shaft goes around.
If its close to 3 times... you have 3.07s
close to 3.5 time but a little over.. most likely 3.73
4 times.... 4.11's
I can't recall how to do it with an open diff though....
|04-05-2012 02:42 PM|
TJDave is right.... if you have a shop do it ( highly recommended unless you have done it numerous times) buy everything from them so the warranty is in tact.
Cost wise.... yeah... $300-$600 per axle sounds like its in the ballpark... plus bearings and shims and seals and R&P.....
|04-05-2012 12:06 PM|
I have heard costs ranging from $3-$600 per axle on a re-gear. One thing that always comes up is if you have a shop do it, buy the gears from them. That way if anything goes wrong, they will warranty the work, and not blame the gear set you provided.
|04-05-2012 11:55 AM|
|Bama-Jeeper||No its a manual, and how expensive/difficult was it to have your diff regeared?|
|04-05-2012 11:49 AM|
Is your 04 X and automatic? My 04 X is, and it came from the factory with 3.73 gears. If yours has the 42rle automatic, I don't see why it would be any different.
I found this interesting: My speedo was around 10 mph off when I moved up to 33" tires, and still had stock gearing.
Now, I have 4.88 gears, and 35" tires. I checked my speedo with a GPS and it is spot on. I did not have to change speedo gears!
|04-05-2012 11:44 AM|
|04-05-2012 11:37 AM|
If you really want to know... Grab 2 qts of diff lube and a tube of RTV. Pop the diff cover and read the numbers on the ring gear. Divide the larger number by the smaller number to get your ratio.
Example from ring:
|04-05-2012 10:58 AM|
|Lbailey21||Means you need $$$$$$$|
|04-05-2012 10:51 AM|
|04-05-2012 10:02 AM|
1. Im need to change the speedo gear & can't seem to figure out how to discover what the gear ratio is? I looked at the charts i've found and its somewhere between 3.55 & 5.13. I have a 4" Lift with 33's.
2. Also, when I upgrade to 35's, i've heard that "re-gearing" will be needed/helpful...what does that mean?
Please help a newb out. Always willing to learn!