|06-09-2012 05:13 PM|
|06-09-2012 05:07 PM|
|06-08-2012 06:43 PM|
same thing happened to me. what s nightmare.
replaced tthe O2 sensor, still stalled.
replaced the throttle body sensor. still stalled.
ended up being the fuel pump and throttle body sensor combination.
|06-06-2012 05:13 AM|
NEVER ever trust the gap on plugs out of the box!
|06-05-2012 10:28 PM|
Your plugs aren't gapped properly.
I know most will argue with me on this one but I am learning the hard way
|04-21-2012 10:45 AM|
|04-21-2012 10:18 AM|
|Jerry Bransford||Does the engine rev up from idle smoothly if you apply the gas slowly and smoothly? I'm beginning to think TPS (throttle position sensor) now.|
|04-21-2012 10:12 AM|
|TJe0454||gave the IAC a good cleaning. still stalling out|
|04-20-2012 09:43 AM|
Don't push/pull/spin the IAC's plunger.
|04-20-2012 08:20 AM|
|TJe0454||my mistake: i cleaned the throttle body and sprayed cleaner into the IAC. i guess ill take the IAC apart and give it a good cleaning now.|
|04-19-2012 12:52 PM|
|Blackpony04||I've been fighting similar issues and since you didn't specifically mention it be sure to check your IAC.|
|04-18-2012 10:34 PM|
|TJe0454||i got the alternator and battery tested when it first started acting up. alternator was good, battery needs to be replaced apparently. i did do some heavy winching a week or so before this all started up...|
|04-18-2012 10:02 PM|
|TJe0454||mines an 01. no distributor.|
|04-18-2012 09:40 PM|
|Fitzey5435||Change the distributor cap and rotor. Moisture is makin you chug and stall out. Sounds like misfire.|
|04-18-2012 09:12 PM|
|TJe0454||its not throwing any codes|
|04-18-2012 05:51 PM|
Is the CEL on? If so pull the codes and post them up here.
If not, it could be a number of things. ( clogged/dirty filters, bad fuel)
|04-18-2012 05:15 PM|
|Georges98TJ||May be the crank sensor try to get it to autozone and have them pull the codes|
|04-18-2012 04:34 PM|
4.0 randomly dying at stops.
as the title says, my engine has been hard starting and dying when cold. also sometimes when at a complete stop. i seafoamed it a week ago. is it possible that caused the issue? just replaced spark plugs because i thought they had been fouled by the seafoam. cleaned throttle body and MAF sensor. thoughts?
maybe bad compression in a cylinder? i just dont know why it would surface now...