Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > What did you do to your JK today?

Join Wrangler Forum Today


Thread: What did you do to your JK today? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
Today 06:53 PM
RHuckster Finished up our homemade rubber rear cargo mat. I had bought a RR cargo mat but it didn't fit to well.

Rick
Today 06:33 PM
RHuckster
Quote:
Nice! Thinking about doing these as well. How was the install?
Thanks, the lower nut on both sides where a bit tricky but can be done with a 1/4" drive rachet. Other than that it was easy.

Rick
Today 06:12 PM
Ndig29 Power-washed and waxed it
Today 05:55 PM
JE01 Having Rusty's Gusset kit installed for my Dana 30
Today 05:41 PM
dmako
Quote:
Originally Posted by jt5280 View Post

FYI I drilled the hole for the camera with the included bit (I got kit off Amazon) and then used a smaller bit for the back (to put the cable through) without taking the bumper off.
Interesting you are able to drill from inside must be tight.

I want to remove silver sahara trim that way if camera doesn't work etc. Trim back on hole covered

PS I have same camera with bit Geino
Today 05:02 PM
jkucod12
Quote:
Originally Posted by Shifty219 View Post
Went for our weekly Jeep meet ride on a nice easy trail


https://www.youtube.com/watch?v=lL64UuLH_Go

Team work A+++

Eagle mine road - YouTube
Today 04:57 PM
jt5280
Quote:
Originally Posted by dmako View Post
Nice! I have camera just need the time to do the same

Any tips on getting bumper back on alignment wise?

Are you running cables on passenger side or drivers side and why?
FYI I drilled the hole for the camera with the included bit (I got kit off Amazon) and then used a smaller bit for the back (to put the cable through) without taking the bumper off.
Today 04:52 PM
Khatton
Quote:
Originally Posted by jsherm007 View Post
Jammock... Next dead pedal.
Got my Jammock a couple weeks ago, those things are awesome.
Today 04:46 PM
jsherm007 Jammock... Next dead pedal.
Today 04:34 PM
MJRob Put my decal on the drivers side
Today 04:26 PM
Franko-s jk Changed the fluids in the transmission,transfer case and the differtials
Today 04:23 PM
4DoorCrush Front and rear bombshell diff covers and sitting at my for something to do when I get home
Today 04:17 PM
1quick1
Quote:
Originally Posted by krbshappy71 View Post
Removed dealership logo under tailgate lock and put on an Apple sticker.

Attachment 1348953

I would have taken a farther-back pic but the reflection was at an all-time high.
The Apple stickers always scream to me "hey look, I possibly have a very expensive piece of technology in the vehicle"

Looks better than the dealer sticker though.
Today 04:12 PM
Jeepman80
Quote:
Originally Posted by dmako View Post
Nice! I have camera just need the time to do the same Any tips on getting bumper back on alignment wise? Are you running cables on passenger side or drivers side and why?
I did it on the passenger side because I have less traffic in my passenger seat to have anyone to pull on the wires accidentally another thing I did was for the bumper alignment was on the actual brackets on bumper take a piece of chalk or tape and outline it on the frame so it will be very easy to put back on all u have to do is line up the chalk marks good luck
Today 04:11 PM
Khatton Blacked out the muffler with high temp 2000 degree black paint. I like it much better than the look of some random aluminum muffler on an already blacked out Jeep.
Got a quote from discount tire for 33's and some 16 inch wheels. Going in tomorrow to seal the deal.
Today 03:59 PM
tuhmayo My jk had really been getting me mad lately, never starts without me putting it in neutral and now it doesn't even start then most of the time I have to crank it for 10-15 min before it starts about it sell it honestly
Today 03:20 PM
dmako
Quote:
Originally Posted by Jeepman80 View Post
My Sunday Project
Nice! I have camera just need the time to do the same

Any tips on getting bumper back on alignment wise?

Are you running cables on passenger side or drivers side and why?
Today 03:14 PM
doctorsteve
Quote:
Originally Posted by DonJulio9 View Post
Nice! Thinking about doing these as well. How was the install?
Super easy. Takes about a half hour.
Today 03:03 PM
cdeslandes Finally received my Superflow MV50 compressor today. My trail kit is now pretty much complete.
Today 02:50 PM
Shifty219 Went for our weekly Jeep meet ride on a nice easy trail


https://www.youtube.com/watch?v=lL64UuLH_Go
Today 02:18 PM
Jeepman80 My Sunday Project
Today 02:08 PM
jcmorgan31 Finished installing my Teraflex 2.5" lift last night.

Next mod - plastidipping the wheels...
Today 02:03 PM
DonJulio9
Quote:
Originally Posted by RHuckster View Post
Installed the Rugged Ridge Black Aluminum Hood Catch's this morning.

Rick
Nice! Thinking about doing these as well. How was the install?
Today 12:45 PM
ArmyofMike Install Proline Gutter Roof Rack (only $68!) to my old Roof Basket. Just afforded myself much more real estate on the JK for light gear/chairs/fishing equipment/sleeping bags/etc just in time for camping this weekend...and next!

(And yes, the rack does fit out my garage. Although it is very close to the ceiling trim! )



Today 12:00 PM
Matos Installed matte black hood decal

Also installed 3" mirrors and used Velcro on the back for easy interchanging when wanting to take my doors off, $5 suppose to rugged ridges $55 ones.
Today 11:15 AM
Cwhite
Quote:
Originally Posted by ring31 View Post
This is the one that I ordered from Amazon. Fumoto F106N http://www.fumotousa.com/parts.php?partnumber=33
Got mine from river raider
Today 11:10 AM
RHuckster Installed the Rugged Ridge Black Aluminum Hood Catch's this morning.

Rick
Today 10:05 AM
KKoenig Pre-ordered this calibration dongle - software runs on iPhone/iPad

http://gopoint-technology.mybigcomme...order-deposit/
Today 09:52 AM
04ORX I ordered a flashcal the other day.
But on your comment about macs. They are not mac compatible. You have to have a pc. Which is a bummer for me since I only have a mac at home. But I do have access to a pc.
After that it's no more mods for me. The wheels and tires took all my funds.
Today 09:02 AM
DuneSahara13
Quote:
Originally Posted by rox-n-mud View Post
How do you download the off-road package?
If you're using windows (I can't speak for mac) you should have already downloaded the Spark Updater

Attachment 1350969

This is the program you use to periodically update the tuner. Now since I don't have mine here at the office I can't show you the next screen as it requires the unit to be plugged in...but once the Spark is open and has check for updates there will several squares and one of them will be the TPMS Offroad download for free. Once you download it it'll apply to the tuner and you can then apply it to the Jeep.
This thread has more than 30 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:01 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC