Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Need Leaf Spring Help!!!!!!!!!

Join Wrangler Forum Today


Thread: Need Leaf Spring Help!!!!!!!!! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-24-2008 05:10 PM
jeepnewbie Thanks guys. What I also did not know was that once you replace them to lower the jeep and they will slide right in. I snugged up the springs but still need to to the drivers side and will be aware to loosoen up the passenegr side to allow for fit.


Thanks again guys!!!
05-24-2008 02:38 PM
MoA even tho i have a tj.. when i was doing my axle swap i had problems with lining the control arm mounts with the control arms

coyotes right, loosen the other side and line it up.. it'll make it 100x easier
05-24-2008 02:34 PM
distortedtj or use the BFH and pissed off method.

J/K dont do that. try the COYOTE method.
05-24-2008 02:29 PM
Doc S. I just did mine. 4" RC. Removed both rear springs, hooked up the new springs to the new shackles and frame mounts then set the axle where it needed to be. you may have to loosen up and push like coyote said.
05-24-2008 02:08 PM
Coyote_94YJ Sounds like the axle shifted a bit. You'll probably have to loosen the driver side and move the axle to get it to line up. And don't torque it down till you change out the driver side or you'll have the same problem.
05-24-2008 01:53 PM
jeepnewbie
Need Leaf Spring Help!!!!!!!!!

Okay! Got a 4" spring lift. I removed the old leaf spring on the rear passenger side and the new one does not line up!!!

The pin sticking out of the wedge is sitting about a 1/2 inch behind the hole in the plate in the axel. According to the instructions the fat side of the wedge goes towrd the front of the jeep. This is so frustarting...any help would be great!!!

Thanks in advance!!!

I won't mention that the track bar bolt on the frame rail is merely held on by only a shank since the nut and bolt head snapped off

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:22 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC