|05-21-2012 10:33 AM|
|05-21-2012 10:00 AM|
Not sure what you mean.
I don't have anything connected yet. The wires I mentioned are coming out of a single tube. Out of these some are still connected to the original harness and some have been clipped and are hanging loose.
|05-20-2012 06:11 PM|
|Jma20a||is there wire harness between the stereo and the factory wiring?|
|05-20-2012 03:52 PM|
diagram found but not the same
I found this but it is not the same as my wires for some reason:
1994 Jeep Wrangler Stereo Wiring Information
Radio Constant 12V+ Wire: Red/White
Radio Switched 12V+ Wire: Purple/White
Radio Ground Wire: Black
Radio Illumination Wire: Blue/Red
Radio Dimmer Wire: Red/Black
Left Front Speaker Wire (+): Gray
Left Front Speaker Wire (-): Yellow
Right Front Speaker Wire (+): White/Red
Right Front Speaker Wire (-): Brown/Red
Left Rear Speaker Wire (+): Gray/White
Left Rear Speaker Wire (-): Brown/White
Right Rear Speaker Wire (+): White/Black
Right Rear Speaker Wire (-): Brown
|05-20-2012 02:42 PM|
Stereo Wiring in 1994 Wrangler
I just bought a 1994 Wrangler and I am trying to put a aftermarket stereo in it the wires coming from the stereo seem to be the basic general wires but I can't figure out what the ones coming out of the jeep are. I've done some research but can't seem to find anything that matches up with my wires. Also I should note that there was an after market stereo in the jeep before and some wires coming from the car are still connected to the original clip and some are not.
The stereo wires coming out of my jeep are.
Does anyone know how these wires would match up with the conventional wires coming out of a head unit?