Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > Solution to removing Safety Torx Screws with bent pins

Join Wrangler Forum Today


Thread: Solution to removing Safety Torx Screws with bent pins Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-26-2008 12:16 AM
sean42069 i have a snap-on automatic center punch i use to break the centers out of those retarded "safety" torx bits.
just a couple quick hits and those pins shoot halfway across the shop
06-25-2008 11:06 PM
Triple88a The lesson of that i think is torxs suck BTW autozone stuff is cheap quality and they get screwed up easy, get something good so you dont end up damaging the bolts because those are tough to undo once stripped.
06-25-2008 05:27 PM
Jerry Bransford I made it a point of using a punch pin to snap all those little security pins out entirely. Just a tap or two with a hammer and smaller diameter punch pin from the side and they're brittle enough to just snap off and cause no more problems.
06-25-2008 05:26 PM
4point Hey
06-25-2008 05:16 PM
SpartanDrew
Solution to removing Safety Torx Screws with bent pins

I came across a problem while trying to remove the forward roll cage bars that connect the rear cage to the front windshield on my 2004 Wrangler. I inserted the safety torx wrench (bought from a local autozone), attempted to loosen the safety torx bolt, and the wrench slipped out.

After inspection, I realized that I had just bent the safety pin (inside the safety torx bolt) downward, thus prohibiting the wrench from being inserted again. To fix it, I did the following.

1) bent the pin back upwards as far as I could using a flat head screwdriver as a chisel and a hammer (caveman approach)
2)Placed the safety torx wrench over the pin and the bolt, and hammered it until the pin shaved down enough, so the wrench could be fully inserted to allow bolt loosening.

Lesson: Be sure that your safety torx wrench is fully inserted into the bolt before applying a torque to loosen the bolt.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:33 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC