|06-08-2012 01:57 AM|
|95 wrangler sahara||OK, I can put this one to bed. The problem was a direct short from the O2 sensor wire that melted to the exhaust manifold.|
|06-05-2012 11:22 PM|
Coil and PCM
Replaced the coil and the PCM( computer aka ecm/ecu.
Jeep starts perfect.
Piece of advice.... Make sure your plugs are gapped properly
|06-03-2012 09:47 PM|
|lonniedean2716||What is the pcm sensor?? IV only replaced the crankshaft position sensor. I don't get no spark out of the coil pack changed the fuses bought new distributor and of course the coil pack?|
|06-03-2012 09:13 PM|
|Fitzey5435||Im in the same boat. My mechanic is replacing the PCM in my 2000 TJ tomorrow morning. Keeping my fingers crossed. Just curious.... WHat sensors did you guys replace??|
|06-03-2012 07:27 PM|
|lonniedean2716||I would like to know this too. I lost fire and have been replacing everything I think of and still no luck?|
|06-03-2012 07:04 PM|
|95 wrangler sahara||
I have been having a hard time trying to find out why my YJ will not start. To make a long story short My jeep stopped will not start because it keeps blowing the fuel pump fuse. I have replaced the Fuel Pump, Fuel Filter and Ignition Switch.
The fuse will not blow until I turn the key to the ON position. I did a lot of wire tracing and found all the wires to be in good condition. What I did find was when the key is turned to the on position the fuel pump positive lead at the fuse panel will ground out causing the fuse to blow. After unplugging several connectors, the test light went out when I unplugged the computer. I also was not able to get the computer to give me any trouble codes because the computer would not even go into access mode.
So my question is, how do you know when the computer is bad and can you test it.
Thanks you your help.